This paper presents an experimental investigation into the effects of contact conformity, contact pressure and displacement amplitude on the gross-slip fretting behaviour grease-lubricated cylinder-on-flat contacts in the context of flexible marine riser pressure armour wire, and compares behaviour with that observed in unlubricated conditions. Characterisation of friction and wear is critical to fretting fatigue life prediction in flexible risers since friction directly controls trailing-edge fretting stresses and hence fatigue crack initiation, on the one hand, and on the other hand, directly affects wear via relative tangential slip (displacement). Wear can have a beneficial or detrimental effect on fatigue crack initiation and propagation, depending on relative slip and slip regime. It is shown that friction and wear are higher for dry conditions than for grease-lubricated conditions. For grease-lubricated conditions, behaviour is determined by whether grease can be retained in the contact (as opposed to being extruded out). Retention (or replenishment) of grease in the contact results in low rates of wear and low coefficients of friction; these conditions are favoured by fretting displacements above a critical value, by low contact conformity, and by low applied loads
Metal additive manufacturing (AM) processes, viz laser powder bed fusion (L-PBF), are becoming an increasingly popular manufacturing tool for a range of industries. The powder material used in L-PBF is costly, and it is rare for a single batch of powder to be used in a single L-PBF build. The un-melted powder material can be sieved and recycled for further builds, significantly increasing its utilisation. Previous studies conducted by the authors have tracked the effect of both powder recycling and powder rejuvenation processes on the powder characteristics and L-PBF part properties. This paper investigates the use of multiple linear regression to build empirical models to predict the part density and surface roughness of 316L stainless steel parts manufactured using recycled and rejuvenated powder based on the powder characteristics. The developed models built on the understanding of the effect of powder characteristics on the part properties. The developed models were found to be capable of predicting the part density and surface roughness to within ±0.02% and ±0.5 Ra, respectively. The models developed enable L-PBF operators to input powder characteristics and predict the expected part density and surface roughness.
19 May 2022 in Journal of Manufacturing Science and Engineering
Laser-based powder bed fusion (L-PBF) of AlSi10Mg can be used to fabricate complex, light-weight structures with high thermal conductivity. Much effort has gone into investigating the mechanical behavior of L-PBF components; however, few studies investigated their thermal properties. This investigation characterizes the effect of process parameters on the relative density and thermal conductivity of L-PBF AlSi10Mg. Exposure time, laser power, pointwise distance, and build orientation were examined. Results show that changing these parameters can affect the thermal conductivity by up to 22%. For example, build orientation and pointwise distance influenced the thermal conductivity by 12.9% and 10%, respectively. As the pointwise distance increased, both the conductivity and the distance between the melt pool boundaries decreased, whereas the laser power had a negligible effect on both. The effect of exposure time was mainly dependent on the pointwise distance. It is shown that thermal conductivity is not only related to the relative density of the samples, but the number of the melt pool boundaries in the microstructure also plays a significant role in interrupting the heat flow. A new factor is introduced to account for the number of melt pool boundaries per unit length in the direction of heat flow, which helps to explain the variation in thermal conductivity for samples manufactured with high energy densities which had almost negligible difference in relative density.
29 September 2022 in Journal of the Brazilian Society of Mechanical Sciences and Engineering