We present a new concept of three-dimensional (3D) polymer-based 1x4 beam splitter for wavelength splitting around 1550 nm. The beam splitter consists of IP-Dip polymer as a core and polydimethylsiloxane (PDMS) Sylgard 184 as a cladding. The splitter was designed and simulated with two different photonics tools and the results show high splitting ratio for single-mode and multi-mode operation with low losses. Based on the simulations, a 3D beam splitter was designed and realized using direct laser writing (DLW) process with adaptation to coupling to standard single-mode fiber. With respect to the technological limits, the multi-mode splitter having core of (4x4) μm2 was designed and fabricated together with supporting stable mechanical construction. Splitting properties were investigated by intensity monitoring of splitter outputs using optical microscopy and near-field scanning optical microscopy. In the development phase, the optical performance of fabricated beam splitter was examined by splitting of short visible wavelengths using red light emitting diode. Finally, the splitting of 1550 nm laser light was studied in detail by near-field measurements and compared with the simulated results. The nearly single-mode operation was observed and the shape of propagating mode and mode field diameter was well recognized.

Due to the increasing trend of photonic device miniaturisation, there is also an increased need for optical splitting in a small volume. We propose a smart solution to split light in three dimensions (3D). A 3D optical splitter based on multimode interference (MMI) for the wavelength of 1550 nm is here designed, simulated, fabricated and optimised for splitting at 1550 nm. We focus also on the possibility of its direct integration on an optical fibre. The design is focused on the use of 3D laser lithography based on the direct laser writing (DLW) process. The output characteristics are investigated by near-field measurement, where we confirm the successful 1 × 4 splitting on a 158 µm long MMI splitter.

Planar MMI couplers based on inorganic material platforms have played an essential role in photonic integrated circuits development. Advances in organic polymer fabrication techniques enable the design of components beyond a single plane, thus facilitating vertical integration for a wide range of components, including the MMI coupler. This paper presents the design of two 3D IP-dip polymer-based MMI power splitters operating in the near-infrared part of the spectrum at a wavelength of 1550 nm. The resulting output power ratio, modal field distributions, spectral characteristics, and the effects of input fibre misalignment are investigated using the beam propagation method. The fabrication method used to realise the designed splitters was direct laser writing. The function of the splitters was then verified by a highly resolved near-field scanning optical microscope.

Design, simulation, and optimization of the $1\times 4$ optical three-dimensional multimode interference splitter using IP-Dip polymer as a core and polydimethylsiloxane (PDMS) Sylgard 184 as a cladding is demonstrated. The splitter was simulated by using beam propagation method in BeamPROP simulation module of RSoft photonic tool and optimized for an operating wavelength of 1.55 $\mu\mathrm{m}$ . According to the minimum insertion loss, the dimensions of the splitter were optimized for a waveguide with a core size of $4\times 4\ \mu \mathrm{m}^{2}$ . The objective of the study is to create the design for fabrication by three-dimensional direct laser writing optical lithography.