Iron oxyfluorides with large tetragonal polar distortions are expected to exhibit multiferroic properties that coexist with their ferroelectric and magnetic orders. However, oxyfluoride multiferroicity has not been experimentally confirmed in polycrystals, owing to their high leakage currents and the presence of impurity phases. In this study, we fabricated single-crystalline Ba-doped bismuth iron oxyfluoride thin films by combining pulsed laser deposition with topochemical fluorination and investigated their room-temperature ferroelectric and magnetic properties. The substitution of Ba at the Bi site in the precursor films was found to play an important role in the introduction of fluorine into the precursor. The Bi1−xBaxFeO3−xFx (x = 0.2, 0.3) films exhibited ferroelectricity and a small magnetization at 300 K. Moreover, electronic structures due to the F 2p states were formed in the valence and conduction bands of the Bi1−xBaxFeO3−xFx (x = 0.2, 0.3) films. The findings demonstrate the potential of oxyfluoride compounds, thereby broadening the range of materials that can be used as room-temperature multiferroics.
1T’-MoTe2 has gained considerable attention owing to its topological character. This material undergoes spatial inversion symmetry at 300 K. A structural transition to the Td phase, which is represented by a kink in the resistivity, was observed below 250 K without inversion symmetry along the c-axis, while superconductivity was observed at 0.1 K. Substitution of Se into this material suppressed the appearance of the kink structure and increased the superconducting transition temperature to 2 K, which is consistent with previously reported results on polycrystalline samples. However, a specific heat jump was observed in the obtained single crystals, which did not exhibit kink structures in their resistivity. The results suggest that the Td structure was not suppressed entirely after Se substitution and that superconductivity was achieved without inversion symmetry.
Indium-addition synthesis of a misfit layered compound (SnSe)1.16(NbSe2) was found to obtain a novel sample (In-sample) with another stacking structure in (SnSe)1.16(NbSe2), causing the increase in the superconducting transition temperature Tc and the in-plane upper critical field μ0 (0). Crystal structure analysis using single crystals revealed that the In-sample has a significantly elongated lattice constant along the c axis due to thickening of the layer other than the NbSe2, while retaining the original misfit layered structure. The Tc increased from 3.6 K to 5.4 K in the In-sample. Furthermore, the in-plane upper critical fields μ0 (0) exceeded the Pauli limit μ0Hp, reaching 29.4 T (μ0Hp ~ 10 T). The coherence length along the c axis was reduced in the In-sample, indicating enhanced two-dimensionality. These results suggest that the In-sample not only has another stacking structure but also exhibits higher Tc and μ0Hc2.