Flooding of post-mining voids is one of the most common methods of post-mining areas reclamation. The article presents selected post-mining lakes investigated within the research project “Risk assessment of final pits during flooding” (RAFF), co-financed by the Research Fund of Coal and Steel and the Polish Ministry of Education and Science. The main objectives of the project are focused on the development of comprehensive models that can be used for risk assessment purposes. The innovative outcomes of the project will help to elaborate methodologies and guidelines to improve the safety and security of the flooding of post-mining open pits as well as sustainable management of the environment. In this paper, the results of bathymetry surveys carried out on pit lake Lubstów belonging to the PAK Konin Lignite Mine SA are presented.

The article presents the impact of lignite mining on the environment associated with the introduction of hydro borehole mining (HBM) technology. The results are partially based on the HydroCoal Plus project results, where an environmental assessment of lignite HBM technology was performed. In order to reach the goals of the task, a life cycle assessment (LCA) study was used to assess selected environmental aspects of the HBM single-borehole lignite production process covering selected environmental impact categories such as energy consumption, fuel consumption, water consumption and carbon footprint. The LCA procedure was adapted in an innovative way, constituting another added value to the shown research. The second part of this paper describes opportunities identified by the authors to minimize the environmental impact of lignite production by implementing the HBM method compared to the conventional opencast method.

Thermoelastic Stress Analysis (TSA) is one of the very few methods allowing the determination of a continuous stress distribution on the object’s surface under variable loading conditions. Such results provide a lot of valuable information in the field of technical condition assessment and residual life prediction. In order to improve the accuracy of the TSA, the Lock-In signal processing method is implemented. This research is aimed at verifying the effectiveness of this improvement and determining the TSA stress detection threshold, as it is important information in terms of the applicability of this method in the low-stress conditions encountered in considerations of fatigue of load-carrying structures. A steel sample with a centrally located hole was subjected to cyclic loads to determine the threshold of stress detection and accuracy of TSA. As a result of the research, the relationship between the magnitude of stress excitations and the underestimation of the measured stresses was developed. Based on the conducted investigations, it was concluded that reasonable TSA results can be acquired for excitations that induce a temperature response above 10 mK (0.5 NEDT). The presented field test example proves that in industrial applications reasonable results can be acquired for thermal responses below the NEDT of the IR camera. It was concluded that it is possible to successfully implement TSA in low-stress applications (temperature response below NEDT).