The presented work is devoted to the preparation of nanocomposites based on multiwall carbon nanotubes (MWCNTs) and copper (Cu) nanoparticles by a simple chemical method, and to study their sensing properties to hydrogen sulfide (H2S) gas. The Cu decorated multiwall carbon nanotubes (MWCNTs/Cu) were prepared by the deposition of very thin Cu layers on the pristine and functionalized multiwall carbon nanotubes (f-MWCNTs) using both physical (electron beam evaporation (EBE)) and chemical (electrochemical deposition) methods. MWCNTs/Cu prepared in the two above-mentioned ways, their sensing properties were studied, and the results were comparatively analyzed. The effect of the chemical functionalization of MWCNTs by oxygen-containing groups on the sensing properties of these f-MWCNT/Cu nanocomposites has been investigated. All the prepared sensors demonstrated high sensitivity and selectivity to H2S in the air at room temperature. The f-MWCNT/Cu structure obtained by the chemical method demonstrated about 5 times (~400%) higher sensitivity (∆R/R0) to H2S gas compared to the similar structure obtained by the physical method. The temperature effect on sensory characteristics (response and self-recovery time) of the f-MWCNTs/Cu structure was also studied.
21 August 2023 in Fullerenes, Nanotubes and Carbon Nanostructures
Thin Bi2Se3 films were successfully electrodeposited from a non-aqueous ethylene glycol-based electrolyte and subsequently underwent thermal treatment in an Ar atmosphere to improve crystallinity. The phase and compositional properties of the films were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), Fourier-transform infrared spectroscopy (FTIR), and Raman spectroscopy. XRD and Raman analyses confirmed the formation of crystalline rhombohedral Bi2Se3, while FTIR measurements indicated minor surface oxidation. The electrical and semiconductor properties of the films were investigated through current–voltage and temperature-dependent conductivity measurements. The activation energy associated with intrinsic conduction was determined to be 0.25 eV, while the temperature sensitivity coefficient and temperature coefficient of resistance were found to be 2903 K and 0.032–0.013 K−1, respectively. Infrared photoconductivity measurements in the wavelength range of 2800–4000 nm revealed a pronounced photoresponse near the band-gap energy of Bi2Se3. The obtained results demonstrate the potential of electrodeposited Bi2Se3 thin films for infrared-sensitive semiconductor and optoelectronic applications.
The presented work deals with the combined effect of cobalt(II) acetylacetonate Co(acac)2 and the anionic surfactant sodium dodecyl sulfate (SDS) on the oxidation of ethylbenzene. This combination forms a new catalytic system for the decomposition of hydroperoxide ROOH operating in the absence of oxygen. SDS taken alone promotes the decomposition of ROOH into phenol and acetaldehyde, and Co(acac)2 into methylphenylcarbinol and acetophenonone. The nature and scale of the influence of microheterogeneity and kinetic heterogeneity of the medium on the kinetics and mechanism of ethylbenzene oxidation and the decomposition of ethylbenzenehydroperoxide in the presence of the above combinations was studied. Using this example, it has been established that the catalysis of the decomposition of hydroperoxide in the presence of combinations of sodium dodecyl sulfate with acetylacetonate cobalt is associated with their colloidal feature leading to the formation of aggregates of the surface active substance and hydroperoxide, such as reverse micelles, which facilitate the cleavage of the peroxide bond.