MXene materials have the metallic conductivity of transition metal carbides. Among them, Ti₃C₂T_X with an accordion structure has great application prospects in the field of wearable devices. However, flexible wearable electronic devices face the problem of single function in practical application. Therefore, it is particularly important to study a flexible sensor with multiple functions for electronic skin. In this work, the near-field electrohydrodynamic printing (NFEP) method was proposed to prepare the composite thin film with a micro/nanofiber structure on the flexible substrate using a solution of poly(vinylidene fluoride)/MXene nanosheet/reduced graphene oxide (PMR) nanocomposites as the printing solution. A dual-mode flexible sensor for electronic skin based on the PMR nanocomposite thin film was fabricated. The flexible sensor had the detection capability of the piezoresistive mode and the piezoelectric mode. In the piezoresistive mode, the sensitivity was 29.27 kPa⁻¹ and the response/recovery time was 36/55 ms. In the piezoelectric mode, the sensitivity was 8.84 kPa⁻¹ and the response time was 18.2 ms. Under the synergy of the dual modes, functions that cannot be achieved by a single mode sensor can be accomplished. In the process of detecting the pressure or deformation of the object, more information is obtained, which broadens the application range of the flexible sensor. The experimental results show that the dual-mode flexible sensor has great potential in human motion monitoring and wearable electronic device applications.

Conducting polymer thermoelectric (TE) materials have received great attention due to their unique properties. In this work, polypyrrole (PPy)/single-walled carbon nanotubes (SWCNTs) composite films with improved TE performance have been prepared by chemical interfacial polymerization at the cyclohexane/water interface under a controlled temperature. Attributed to the smooth surface, higher conjugation length and more ordered molecular structure of the interfacial polymerized PPy film, the electrical conductivity can be as high as ∼500 S cm⁻¹. To further enhance the TE properties of PPy, SWCNT was added to construct a PPy/SWCNTs composite. Due to the synergistic effect between the two phases and the energy filtering effect at the interfaces between PPy and SWCNTs, the Seebeck coefficient of the composite enhanced significantly with the increase SWCNTs content. The composite shows an optimal power factor of 37.6 ± 2.3 μW mK⁻² when the content of SWCNTs is 0.8 mg. This value is one of the largest values among the reported PPy based composites fabricated by the chemical polymerization method. The results indicate that interfacial polymerization under a controlled temperature is a promising way to improve the TE performance of conducting polymer based composite materials.

Current-induced changes of surface morphology in printed Ag thin wires were investigated by current stressing tests and numerical simulation. The samples were printed Ag thin wires on a flexible substrate with input and output pads. Different experimentalresults were obtainedthroughchangingthe current density after current supply and the mechanism of those phenomena were investigated by numerical simulations based on the method of atomic flux divergence. Good agreement between the simulations and experimental results was reached. It was found that electromigration was the main factor that caused the change of the surface morphology. The contribution of thermal migration can be ignored, and the Joule heating lead by the supplied current had a very significant accelerating effect on electromigration. Guidelines for effectively changing the Ag thin wire surface through providing predetermined current density was proposed, which were expected to be useful for improving the electrical reliability and lifetime of printed Ag thin wires in flexible electronic devices.

A sensitive and selective electrochemical sensor was constructed by one-step co-electropolymerization of hydroxymethylated-3,4-ethylenedioxythiophene and nitrogen-doped graphene for the trace-level analysis of luteolin in Thymus vulgaris, Lonicera japonica, and Lamiophlomis rotata.