This paper reports an InAs/InAsSb strained-layer superlattice (SLS) mid-wavelength infrared detector and a focal plane array particularly suited for high-temperature operation. Utilizing the nBn architecture, the detector structure was grown by molecular beam epitaxy and consists of a 5.5 µm thick n-type SLS as the infrared-absorbing element. Through detailed characterization, it was found that the detector exhibits a cut-off wavelength of 5.5 um, a peak external quantum efficiency (without anti-reflection coating) of 56%, and a dark current of 3.4 × 10−4 A/cm2, which is a factor of 9 times Rule 07, at 160 K temperature. It was also found that the quantum efficiency increases with temperature and reaches ~56% at 140 K, which is probably due to the diffusion length being shorter than the absorber thickness at temperatures below 140 K. A 320 × 256 focal plane array was also fabricated and tested, revealing noise equivalent temperature difference of ~10 mK at 80 K with f/2.3 optics and 3 ms integration time. The overall performance indicates that these SLS detectors have the potential to reach the performance comparable to InSb detectors at temperatures higher than 80 K, enabling high-temperature operation.
23 November 2011 in IEEE Photonics Technology Letters
We report GaInAsSb-based p-i-n photodiodes operating in the 2-2.4-μm wavelength range grown on GaAs (100) substrates using the interfacial misfit (IMF) array technique. A zero-bias dynamic-resistance-area product of 260 Ωcm2 and a room temperature peak responsivity of 0.8 A/W (at 2 μm) with an estimated maximum detectivity (D*) of ~3.8×1010 cm Hz1/2 W-1 is obtained in the photodiodes at -0.2 V. These preliminary results of the IMF-based GaInAsSb detectors are comparable to similar detectors grown on native GaSb substrates demonstrating the potential of the IMF array growth mode to realize high-quality Sb-based infrared detectors on GaAs substrates.
Strained-layer superlattices (SLSs) are an active research topic in the molecular beam epitaxy (MBE) and infrared focal plane array communities. These structures undergo a >500 K temperature change between deposition and operation. As a result, the lattice constants of the substrate and superlattice are expected to change by approximately 0.3%, and at approximately the same rate. However, we present the first temperature-dependent X-ray diffraction (XRD) measurements of SLS material on GaSb and show that the superlattice does not contract in the same manner as the substrate. In both InAs/InAs0.65Sb0.35 and In0.8Ga0.2As/InAs0.65Sb0.35 SLS structures, the apparent out-of-plane strain states of the superlattices switch from tensile at deposition to compressive at operation. These changes have ramifications for material characterization, defect generation, carrier lifetime, and overall device performance of superlattices grown by MBE.