In this study, a new transverse post-tensioning (TPT) technique for box girder bridges is investigated, where TPT is applied at the top flange of the girder resulting in eliminating the intermediate transverse diaphragms. A one-third-scale bridge model consisting of four adjacent box girders with partial-depth shear keys was erected and tested. The bridge model was investigated for the optimal TPT force and spacing to ensure a uniform distribution of the clamping prestress. The efficiency of the proposed technique in transversely distributing live loads during simulated service and ultimate conditions was also investigated. Test results demonstrated that distributing the TPT force at a shorter spacing along the length of the bridge is more efficient than increasing the TPT force at discrete distant locations in producing the minimum required concrete prestress. It was observed that the effect of TPT force and spacing was insignificant during the simulated service condition, where shear keys remained intact or partially cracked. However, at failure, the presence of TPT added redundancy to the bridge model and mitigated any sudden failure when shear keys were fully cracked.
A three-dimensional non-linear finite-element model (FEM) was constructed using a commercial software (ATENA-Studio) to investigate the transverse load distribution behavior of adjacent precast prestressed concrete box-girder bridges. An innovative connection between box girders was used, where transverse post-tensioning was applied at the top flanges only eliminating the need for intermediate transverse diaphragms. The FEM was validated in terms of deflections, strains, cracking and ultimate loads against experimental results previously reported by the authors. The validated FEM was then used to perform a parametric study investigating the influence of adding concrete topping, load location, and bridge width on the transverse load distribution behavior of the newly developed connection. The results of the FEM demonstrated the efficiency of concrete topping in limiting mid-span deflections up to 25%. Additionally, the maximum live load moment distribution factors (LLMDFs) for different load locations and bridge widths were evaluated.