Gold nanoparticles (AuNPs) and carbon nanotubes (CNTs) are increasingly being investigated for cancer management due to their physicochemical properties, low toxicity, and biocompatibility. This study used an eco-friendly technique (laser synthesis) to fabricate AuNP and Au/CNT nanocomposites. AuNPs, Au/CNTs, and CNTs were tested as potential cancer nanotherapeutics on colorectal carcinoma cells (HCT-116) and cervical cancer cells (HeLa) using a 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyl-2H-tetrazolium bromide (MTT) assay. In addition, the non-cancer embryonic kidney cells HEK-293 were taken as a control in the study. The cell viability assay demonstrated a significant reduction in cancer cell population post 48 h treatments of AuNPs, and Au/CNTs. The average cell viabilities of AuNPs, Au/CNTs, and CNTs for HCT-116 cells were 50.62%, 65.88%, 93.55%, and for HeLa cells, the cell viabilities were 50.88%, 66.51%, 91.73%. The cell viabilities for HEK-293 were 50.44%, 65.80%, 93.20%. Both AuNPs and Au/CNTs showed higher cell toxicity and cell death compared with CNT nanomaterials. The treatment of AuNPs and Au/CNTs showed strong inhibitory action on HCT-116 and HeLa cells. However, the treatment of CNTs did not significantly decrease HCT-116 and HeLa cells, and there was only a minor decrease. The treatment of AuNPs, and Au/CNTs, on normal HEK-293 cells also showed a significant decrease in cell viability, but the treatment of CNTs did not produce a significant decrease in the HEK-293 cells. This study shows that a simplified synthesis technique like laser synthesis for the preparation of high-purity nanomaterials has good efficacy for possible future cancer therapy with minimal toxicity.

In this study, seeded zinc oxide (Z-ZnO) thin films were fabricated by a two-step electrochemical deposition process. Different annealing temperatures (300, 400, 500, and 600 °C) were investigated to determine the most effective temperature for the photocatalytic activity. Comprehensive analyses were conducted using X-Ray Diffraction (XRD), scanning electron microscopy (SEM), and UV–visible spectrophotometry. The XRD results confirmed the formation of a wurtzite hexagonal structure, with the highest crystallinity observed at 400 °C. The lowest band gap value, 3.29 eV, was also recorded for Z-ZnO thin film annealed at 400 °C. SEM images revealed that the thin film treated at 400 °C exhibited a well-defined and uniform structure, contributing to its enhanced properties. The photocatalytic efficiency of ZnO (without seeding layer) and Z-ZnO thin films annealed at 400 °C was evaluated through the degradation of tetracycline hydrochloride (TCH) to prove the effect of the presence of a primary seeding layer on ZnO 400 °C thin film efficiency. The degradation efficiency of ZnO thin film without seeding layer was 69.8%. By applying a seeding layer in Z-ZnO 400 °C thin film, the degradation efficiency has been increased to 75.8%. On the other hand, Z-ZnO 400 °C thin film achieved a high degradation efficiency of 82.6% over 300 min in the photoelectrocatalytic system. The obtained Z-ZnO thin films annealed at 400 °C are highly effective photocatalysts and photoelectrocatalysts, offering a significant potential for the degradation of pharmaceuticals and other pollutants in water.