Quantifying methane (CH4) emissions is essential for climate change mitigation; however, current estimation methods often suffer from substantial uncertainties, particularly at the site level. This study introduces a drone-based approach for measuring CH4 emissions using an open-path Tunable Diode Laser Absorption Spectroscopy (TDLAS) sensor mounted parallel to the ground, rather than in the traditional nadir-pointing configuration. Controlled CH4 release experiments were conducted to evaluate the method’s accuracy, employing a modified mass-balance technique to estimate emission rates. Two wind data processing strategies were compared: a logarithmic wind profile (LW) and a constant scalar wind speed (SW). The LW approach yielded highly accurate results, with an average recovery rate of 98%, while the SW approach showed greater variability with increasing distance from the source, although it remained reliable in close proximity. The method demonstrated the ability to quantify emissions as low as 0.08 g s−1 with approximately 4% error, given sufficient sampling. These findings suggest that the proposed UAV-based system is a promising, cost-effective tool for accurate CH4 emission quantification in sectors, such as agriculture, energy, and waste management, where traditional monitoring techniques may be impractical or limited.
The effective management of landfills requires advancements in techniques for rapid data collection and analysis of gas emissions. This work aims to refine methane (CH4) emission data acquired from landfills by applying a robust geostatistical method to drone-collected measurements. Specifically, we use UAV-mounted laser spectrophotometer technology (TDLAS-UAV) to gather rapid, high-resolution data, which can sometimes be noisy due to atmospheric variations and sensor drift. For data handling, the key innovation is the application of the local indicator of spatial association (LISA), a technique that typically provides p-values to assess the statistical significance of observed spatial clusters. This approach was applied both on an areal basis and on a linear basis, following the order of data acquisition, and it produced comparable results. Very low p-values are considered indicative of non-random clustering, suggesting the influence of an underlying spatial control factor. These results were subsequently validated through independent flux chamber surveys. This validation confirms the reliability and objectivity of our geostatistical method in improving drone-based methane emission assessments. The research highlights the need to optimize drone flight paths to ensure a uniform spatial distribution of data and reduce edge effects. It notes that many CH4 flux measurements often yield non-detectable results, suggesting a review of detection limits. Future work should refine UAV flight patterns and data processing with semi-controlled experiments—using known methane sources—to determine optimal acquisition parameters, such as flight height, sampling frequency, grid resolution, and wind influence.
Quantifying methane (CH₄) emissions is essential for climate change mitigation, yet current estimation methods often suffer from substantial uncertainties, particularly at the site level. This study introduces a drone-based approach for measuring CH₄ emissions using an open-path Tunable Diode Laser Absorption Spectroscopy (TDLAS) sen-sor mounted parallel to the ground, rather than in the traditional nadir-pointing con-figuration. Controlled CH₄ release experiments were conducted to evaluate the method’s accuracy, employing a modified mass balance technique to estimate emission rates. Two wind data processing strategies were compared: a logarithmic wind profile (LW) and a constant scalar wind speed (SW). The LW approach yielded highly accurate results, with an average recovery rate of 98%, while the SW approach showed greater variability with increasing distance from the source, though remained reliable in close proximity. The method demonstrated the ability to quantify emissions as low as 0.08 g s⁻¹ with approximately 5% error, given sufficient sampling. These findings suggest that the proposed UAV-based system is a promising, cost-effective tool for ac-curate CH₄ emission quantification in sectors such as agriculture, energy, and waste management, where traditional monitoring techniques may be impractical or limited.
Reliable and scalable methane (CH₄) monitoring is essential both for near-term climate mitigation and for supporting circular-economy strategies focused on energy recovery and the reduction of losses along value chains. Unmanned aerial vehicles (UAVs) enable facility-scale measurements with high spatio-temporal resolution. However, most studies rely on point sensors that require repeated flights at different altitudes and interpolation from low-density datasets, leading to potentially high uncertainty under turbulent and variable wind conditions. Open-path optical sensors can increase the effective sampling volume and improve plume representativeness, but practical, field-ready frameworks remain relatively under-developed. This study presents an operationally oriented UAV mass-balance framework for facility-scale CH₄ quantification using a drone-mounted open-path TDLAS sensor. The method is demonstrated across three representative emission contexts in Italy. At an intensive dairy cattle farm, UAV-derived net enteric emissions ranged from 0.182 to 0.242 kg CH4 AU⁻¹ day⁻¹ and showed strong agreement with IPCC references, with a maximum deviation of 0.54% relative to Tier 1 and a mean deviation of 4.32% relative to Tier 2. At a natural gas compression facility, site-level emissions of 14.3 ± 4.1 and 11.9 ± 2.6 kg CH₄ h⁻¹ under two operating configurations agreed with an independent Method 21 bottom-up estimate within 9.4–11.6%. At a municipal solid-waste landfill, site-scale fluxes ranged from 3.7 to 11.5 g s⁻¹, with uncertainty dominated by meteorology. Overall, the results show that the proposed open-path framework is transferable across sectors and delivers operationally deployable facility-scale estimates. This supports more frequent, management-oriented monitoring in line with circular-economy objectives.