Azimuthal multi-angle observation (AMAO) is a novel spaceborne synthetic aperture radar (SAR) technique proposed recently, which significantly improves the acquisition performance of target information. It has highly flexible antenna beams with powerful beam-steering capability while affecting the consistency of radiometric measurements, especially in the high-squint case. This paper mainly focuses on the antenna pattern effect analysis and correction method of AMAO spaceborne SAR. The antenna pattern characteristics of the squint steering beam are first analyzed. On this basis, an analytical model is developed to quantify the antenna pattern effects in AMAO SAR images. Different from the conventional approach that corrects the elevation antenna pattern, an improved antenna pattern correction method, which accounts for the spatial variation in the two-dimensional antenna pattern, is then proposed for AMAO spaceborne SAR. Finally, experiments are conducted to verify the proposed correction method. The results show that the newly proposed method considering the spatial-variant antenna pattern has higher performance than the conventional approach using a reference elevation pattern.
A novel space-borne SAR technique, azimuthal multi-angle observation (AMAO), has recently been proposed. It has highly flexible working modes and powerful capability of target information acquisition, but has challenges in achieving radiometric measurement accuracy. The larger the squint angle, the higher the resolution and the more variations involved. Radiometric calibration is a necessary approach to consistent and accurate SAR measurements, but has so far not been carefully considered for AMAO space-borne SAR. This paper addressed the new issues in radiometric calibration arising from the AMAO space-borne SAR system. The AMAO imaging modes are firstly been illustrated, based on which the influences of the AMAO on radiometric calibration are analyzed. To guarantee the accuracy of the radiometric calibration, an appropriate form of the SAR radar equation is derived for AMAO space-borne SAR. On these bases, the calibration models can be obtained by reformulating the novel AMAO SAR equation, and the corresponding normalization method is then proposed. The good experimental performance indicators verify the correctness of proposed models and the effectiveness of the correction method.
The P-band spaceborne SAR system faces the problem of a lack of available reference targets for radiometric calibration. Traditional artificial passive calibrators such as trihedral corner reflectors may be hard to be adopted to P-band SAR calibration because of weight, size, manufacture, and installation cost. The parabolic antenna is considered as a potential calibrator due to its stable scattering characteristics and large RCS. One of the criteria of the calibrator is that the beamwidth of the azimuth RCS pattern needs to be much larger than the SAR antenna beamwidth, which is convenient for alignment and obtaining a constant RCS value. It is generally believed that the parabolic antenna can only be used when it is fully aligned to the SAR sensor. However, the P-band spaceborne SAR system usually has a wide beamwidth because of the long wavelength. In contrast, the azimuth RCS pattern of the parabolic antenna has a narrow beamwidth, which will cause inconstant RCS of the calibrator within the synthetic aperture period, thereby introducing an additional calibration error. Due to the imbalance between the SAR antenna beamwidth and the RCS pattern beamwidth, the criterion of using the parabolic antenna as a calibrator may need further discussion. This article analyzes the influence of the RCS pattern of the parabolic antenna on the radiometric calibration and establishes the quantitative error model. Based on the error model, the error analysis is carried out for the two cases of alignment and misalignment. The theoretical analysis shows that the calibration accuracy will decrease if without additional error compensation despite a fully aligned parabolic antenna. Under the case of misalignment, the parabolic antenna can also be used for calibration, even when introducing smaller errors. To verify this conclusion, the RCS pattern of a parabolic antenna is used for the P-band imaging simulation and calibration simulation. The results show that the narrow RCS pattern will introduce a non-negligible error in the calibration when fully aligned. The parabolic antenna can also assist in calibration in the case of misalignment. In addition, the calibration experiment shows that, after compensation with the error model, calibration accuracy has been effectively improved.