Gary Q. Yang

Dr. Gary Q. Yang

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 May 2022 in Separations
Verified
Journal Article
Open access
PDF file
WCweibin Cai
weibin Cai
MWMingqian Wang
Mingqian Wang
GYGary Q. Yang
Gary Q. Yang
ZZZhijun Zhang
Zhijun Zhang
YWyujun Wang
yujun Wang
JLJiding Li
Jiding Li
Volatile organic compounds (VOCs) are important sources of atmospheric pollutants on account of their high recycling value. The membrane of dense silicone rubber polydimethylsiloxane (PDMS) has wide-ranging prospects for the separation and recovery of VOCs. In this study, PDMS membrane body models were established in BIOVIA Materials Studio (MS) to simulate VOCs with C3/N2 gases, and to study the structure of PDMS membranes and the dissolution and diffusion process of gas in the membranes. The free volume fraction (FFV), cohesive energy density (CED), radial distribution function (RDF), diffusion coefficient and solubility coefficient of C3H8, C3H6 and N2 in PDMS membranes were calculated, and the permeability coefficients were calculated according to these values. At the same time, the effects of temperature and mixed gas on the dissolution and diffusion of C3/N2 in PDMS membranes were investigated. The results show that the mass transfer process of C3 in PDMS membranes is mainly controlled by the dissolution process, while that of N2 is mainly controlled by the diffusion process. In a C3/N2 mixed gas system, there is a synergistic relationship between gases in the diffusion process, while there is competitive adsorption in the dissolution process. With an increase in temperature, the diffusion coefficients of the three gases in PDMS gradually increase, the solubility coefficients gradually decrease, and the overall permeability selectivity coefficients of the gases gradually decrease. Therefore, low-temperature conditions are more conducive to the separation of C3/N2 in PDMS membranes. The simulation results of the permeability selectivity coefficients of pure C3 and N2 in PDMS are similar to the experimental results, and the relationship between the micro- and macro-transport properties of PDMS membranes can be better understood through molecular simulation.

18 January 2023 in Polymer
Verified
Journal Article
Closed access
WCWeibin Cai
Weibin Cai
MWMingqian Wang
Mingqian Wang
GYGary Q. Yang
Gary Q. Yang
JLJiding Li
Jiding Li

27 November 2023 in ACS Applied Bio Materials
Verified
Journal Article
Closed access
GYGary Q. Yang
Gary Q. Yang
WCweibin Cai
weibin Cai
ZZZhiwen Zhang
Zhiwen Zhang
YWYujun Wang
Yujun Wang

6 November 2025 in ACS Omega
Verified
Journal Article
Open access
GYGary Q. Yang
Gary Q. Yang
WCweibin Cai
weibin Cai
TLTiankun Liu
Tiankun Liu
YWYujun Wang
Yujun Wang
LSLiangxia Sun
Liangxia Sun
Extractant selection is the most important aspect for the extraction treatment of phenolic wastewater from the coal chemical industry. Highly efficient extractants are urgently needed. To our knowledge, we identified for the first time one set of coextractants, cyclohexanone and methyl isobutyl ketone (MIBK), after spending plenty of time and energy for the extraction of phenolic compounds, including polyhydroxyphenol, from wastewater. Fourier transform infrared (FTIR) spectroscopy of the solvents before and after extraction shows that intermolecular hydrogen bonding between the molecules of the extractants and phenols is established, contributing to the high performance. The effects of pH, temperature, and salt concentration on the extractant performance were then studied. The extraction favors acidic and neutral pH values. Increasing the temperature has a negative influence on the extraction. The salt effect by putting inorganic salt can obviously enhance the extractant performance. Compared with single extractants such as MIBK and diisopropyl ether (DIPE), coextractants have significantly improved recovery rates of resorcinol and phloroglucinol. To learn if this set of coextractants also has good performance in practical extraction processes for the treatment of industrial wastewater, three-stage countercurrent extraction experiments were carried out with these coextractants for the extraction of phenolic compounds from coal chemical wastewater. Cascade experiments were used to simulate and verify the countercurrent extraction process in actual industry. According to the results, it is observed that this set of coextractants also has good performance in practical extraction processes for the treatment of industrial wastewater.

22 April 2025 in ACS Omega
Verified
Journal Article
Open access
WCweibin Cai
weibin Cai
ZWZezhong Wang
Zezhong Wang
GYGary Q. Yang
Gary Q. Yang
JQJianbing Qian
Jianbing Qian
Furfural can be produced by the acidification and hydrolysis of biomass raw materials, which have the advantages of low prices, abundant sources, and short renewable cycles. High-purity furfural is valuable, but currently, the processes in industry can only obtain furfural with a purity as low as 98.5%. Therefore, people urgently need an industry-applicable purification process to produce high-purity furfural. In this study, a new distillation process was proposed to produce a high-purity furfural. To our knowledge, we are the first to develop such a process. The process has the advantages of large capacity, small device size, high operation stabilities, high operability, and high product purities compared to the single-column batch distillation process. Pilot-scale experiments were performed to verify the modeling results and determine if the process is industry-applicable. The experimental results are in agreement with the modeling ones, and the concentration of furfural in the distillate product is higher than 99.5% and meets the requirements of high-purity furfural.

31 March 2026 in Membranes
Verified
Journal Article
Open access
PDF file
GYGary Q. Yang
Gary Q. Yang
WCweibin Cai
weibin Cai
YWYing Wan
Ying Wan
Liposomes, spherical bilayer lipid-containing vesicles, are promising nanocarriers used for constructing drug delivery systems (DDS). Various strategies can be employed to loosen or break the liposome and release drugs as the tumor cells-targeting DDS made of liposomes reach the targeted sites. One of the most commonly used strategies is to heat the liposomal DDS by letting the gold nanoparticles or other light-absorbing substances that partition in various portions (inner water core, lipid bilayer or outside) of the liposome absorb light irradiation. Then, which portion can lead to the largest liposome structure change due to the same temperature variation? The answer is essential to aid the design of liposomal DDS; thus, wet lab experiments were carried out. However, even though irradiation-absorbing substances in different portions were irradiated for the same time and with the same irradiation intensity, it was impossible to ensure the three portions have the same temperature increase in the experiments. Furthermore, it is impossible to learn the related micromechanism and molecular-level details of the effects of temperature changes on the liposome structure with experimental methods. The molecular dynamics (MD) method is extensively employed by researchers to obtain in-depth molecular-level insights. Most researchers tend to simulate only a planar lipid bilayer structure, but Amărandi et al. demonstrated that such simplification strategy may give wrong simulation results contrary to the experimental results. Though Jämbeck et al. and Zhu et al. established whole spherical liposome systems with a diameter of about a dozen nanometers and simulated the systems with MD simulations, they did not simulate temperature-relevant properties of the liposome. Therefore, currently there is a lack of research on simulating the structure change in a whole spherical liposome due to temperature variations. So, we established the whole spherical structure of the liposome, simulated how it changes with temperatures and obtained molecular-level research results. It is observed that the temperature increase in the lipid bilayer causes the largest increase in lipid strand sway amplitude, the largest changes in lipid positions, the largest decrease in the distribution density of lipids and water around a lipid and the largest decrease in the interactions between lipids and lipids and between lipids and water, leading to the largest change in the liposome structure. We also studied how the degree of lipid tail unsaturation affects liposome structure changes with temperatures. Due to the C3 kinks in the unsaturated lipid tails, the distribution density of unsaturated lipids is not as high as saturate ones, leading to smaller attraction interactions and consequently larger liposome structure change with temperature. The obtained results are useful for the liposomal DDS design for the purpose of improving DDS performances and delivery outcomes.