MAX phases are an advanced class of ceramics based on ternary carbides or nitrides that combine some of the ceramic and metallic properties, which make them potential candidate materials for many engineering applications under severe conditions. The present work reports the successful synthesis of nearly single bulk Ti2AlN MAX phase (>98% purity) through solid-state reaction and from a Ti and AlN powder mixture in a molar ratio of 2:1 as starting materials. The mixture of Ti and AlN powders was subjected to reactive spark plasma sintering (SPS) under 30 MPa at 1200 °C and 1300 °C for 10 min in a vacuum atmosphere. It was found that the massive formation of Al2O3 particles at the grain boundaries during sintering inhibits the development of the Ti2AlN MAX phase in the outer zone of the samples. The effect of sintering temperature on the microstructure and mechanical properties of the Ti2AlN MAX phase was investigated and discussed.
Comminution is the stage with the largest energy consumption in the mining process. Therefore, several pre-treatments have been proposed to reduce the energy requirements of this stage. This work analyzed the effect of a heating pre-treatment on the Bond index. A conventional heating pre-treatment was applied to a Chilean copper ore. The ore was heated to temperatures from 300 to 600 °C using a conventional furnace, resulting in a reduction of 19% in the Bond work index. Due to the pre-treatment, the mineral cracked in several areas. Microfracture and composition analyses of these areas confirmed that crack generation in the ore is due to the thermal stress produced by the pre-treatment. The fracture analysis explains the reduction in the Bond work index, since crack generation started at similar temperatures to those at which the reduction in the Bond work index was observed. In addition, the analysis also shows that micro-cracks occur between and through different phases, which may have an impact on mineral liberation. These results also show that, under a moderate high temperature, an important reduction in energy consumption can be obtained.
23 December 2022 in Environmental Science: Water Research & Technology
This research shows a detailed statistical study based on several scientific articles published in the last few decades related to the electrocoagulation treatment of landfill leachate. The main operational parameters are evaluated and a new factor (J) is defined in terms of the mass of oxidized metal and the initial chemical oxygen demand concentration (COD). Predictive models of COD removal for processes using anodes of aluminum or iron were developed. R2 values of 95.8% and 94.2% were achieved using aluminum and iron anodes, respectively. The standard error of estimate and absolute error were 6.69 and 5.52 for the aluminum anodes, while for the iron anodes, they are 9.26 and 7.43, respectively. The experimental results support the model. The developed model can be helpful as a first approximation in designing EC systems to remove COD from landfill leachate.
15 July 2025 in Sustainable Energy Technologies and Assessments