Radon passive monitors based on solid state nuclear track detectors (SSNTD), especially CR-39, are widely used in radon and thoron studies. They may be subjected to the influence of external factors, like changing of temperature, humidity, and pressure, both before and during the measurement. Evaluation of the exposed detectors involves chemical processing, whose conditions also influence the measurement results. The aim of this study was to check several factors, as to whether they may modify the response of CR-39 detector: concerning the phase before evaluation, storage time, and temperature during storage; and concerning the evaluation procedure, etching time, and pre-etching treatment using hot water and carbon dioxide atmosphere. Two experiments were conducted by irradiation of CR-39 detectors using alpha particles emitted from a mono-energetic ²⁴¹Am source and exposed in radon atmosphere. Track density dependence of the age of production was found to be statistically not significant. On the other hand, pre-etching treatment using hot water and carbon dioxide with different etching times showed statistically significant effects on track area, track sensitivity, and roundness. It was concluded that there are simple methods to increase performance of nuclear track detectors, and that storage time is not a factor of concern.

Indoor radon is a major hazard to human health; it is one of the leading causes of lung cancer. Therefore, radon research in Asia has intensified recently due to the growing awareness of the harm that radon poses. An analysis of the collected literature data showed that in Asia–Oceania, some regions have—or are believed to have—little indoor radon problems due to climate and low Rn ground. It can be concluded that countries have their own approaches, techniques, and protocols. Data were not harmonized within each region; however, measurement techniques were compared by regional intercomparison exercises. The situation differs regarding studies on the usability of radon as a tracer or potential predictor of tectonic phenomena, as some countries are in seismically active zones, such as India, Taiwan, China, Japan, etc. India and Taiwan are global leaders in this research, as well as Italy, which is another seismically affected country. We provide an overview of radon-related surveying and research activities conducted in the western, southern, and eastern Asian regions over the past few years. Additionally, we observed that the number of indoor radon measurements per million inhabitants increases as the human development index (HDI) increases.

Radon, an element of natural radiation, is considered one of the leading causes of lung cancer worldwide. In Bangladesh, radon has been clarified as a foremost source of radiation exposure. Potential natural-radiation-induced elevated cancer risks were estimated in Bangladesh previously for the population. In this survey, as a very preliminary study in the country, comparative indoor radon (²²²Rn, Rn) and thoron (²²⁰Rn, Tn) concentration/population exposure was determined for the multistoried dwellings of south-western areas of Dhaka city. RADUET was used to assess annual Rn and Tn concentrations in determining the primary inhalation dose for the population. The annual effective dose of Rn and Tn was evaluated in this study for dwellings at 0.3 mSvy⁻¹, constituting a Tn dose contribution of an average of 40% with a dwelling-based wide range of 10–96%. Thus, Tn should not be neglected for Bangladesh while estimating radiological inhalation dose from the indoor environment. Again, the equilibrium factors, F of Rn and Tn, were determined by short-term measurement at averages of 0.6 and 0.02, respectively. Furthermore, using questionnaire estimation by principal component analysis, PCA following the dwelling characteristics, human lifestyles, and estimated long-term indoor Rn and Tn concentrations, this paper discussed indoor atmospheric/Rn factors for the investigated multistoried dwellings in Dhaka city.

Building materials, such as brick and concrete, are known indoor radon (²²²Rn) and thoron (²²⁰Rn) sources. Most radon and thoron exhalation studies are based on the laboratory testing of pieces and blocks of such materials. To discuss if laboratory findings can be applied to a real-world environment, we conducted intensive in situ exhalation tests on two solid concrete interior walls of an apartment in Japan for over a year. Exhalation rates of radon (J_Rn) and thoron (J_Tn) were measured using an accumulation chamber and dedicated monitors, alongside monitoring indoor air temperature (T) and absolute humidity (AH_in). There were weak correlations between J_Rn or J_Tn and T or AH_in at one tested wall, and moderate correlations of J_Rn and strong correlations of J_Tn with T or AH_in at the other wall, meaning more or less seasonal variations. The findings aligned with previous laboratory experiments on J_Rn but lacked corresponding data for J_Tn. Additionally, a moderate or strong correlation between J_Rn and J_Tn was observed for both tested walls. Comparison with theoretical calculations revealed a new issue regarding the impact of each process of emanation and migration within concrete pores on radon and thoron exhalation. Overall, this study provides insight into parameterizing radon and thoron source inputs in modeling the spatiotemporal dynamics of indoor radon and thoron.