Microbial fuel cell (MFC) is a renewable clean energy. Microorganisms are used as catalysts to convert the chemical energy of organic matter in the sewage into electrical energy to realize sewage treatment and recover energy at the same time. It has good development prospects. However, the output power of MFC is affected by many factors, and it is difficult to achieve a stable voltage output. For the control‐oriented single‐chamber MFC, a fuzzy integral sliding mode control is designed. The continuous adjustment of the sliding surface ensures that the system only moves on the sliding surface, which eliminates the arrival stage and improves robustness. For chattering existing in the system, the control scheme is further optimized to obtain fuzzy integral sliding mode control, and the fuzzy module adaptively adjusts the control parameters according to the system state, which effectively reduces the system chattering. Experiments prove that the control scheme reduces chattering while ensuring the stable output of the system.
The microbial fuel cells (MFCs) are a kind of green energy with good prospects, which provides an effective solution to the problem of unsustainable development of energy today. Aiming at the problem that MFCs are susceptible to various external disturbances, a sliding mode (SM) controller for MFCs is designed in this paper. The controller can effectively reduce the influence of external disturbance on voltage output and improve the practicability of microbial fuel cells (MFC). At the same time, aiming at the chattering problem of the basic SM control, a fuzzy sliding mode (FSM) control method is proposed by combining the fuzzy logic theory and the SM control. The design method of FSM controller is given by using Lyapunov theory. The method can adaptively adjust the parameters according to the difference between the actual value of the substrate concentration and the set value. The controller can reduce the system input chattering and the influence of external disturbances on the system output. Simulation results show that compared with SM control and backstepping control, the designed method has smaller steady-state error and overshoot.
14 November 2025 in IEEE Robotics and Automation Letters
This letter presents a modular coupled tendon-driven robotichand that employs a 2 motor 2 degrees-of-freedom (2M2D) coupled tendon driven joint module, in which two motors operate in a coordinated manner to actively drive flexion/extension and abduction/adduction of each finger through four tendons fixed to the fingertip. This coupled mechanism significantly enhances output torque while maintaining a simplified layout, each finger and corresponding actuator is implemented as an independent, detachable module, enhancing system flexibility and maintainability. Experimental results demonstrated that the coupled tendon-driven mechanism enhanced fingertip, lateral swing forces and load-bearing capacity by approximately 70$\%$ compared to decoupled tendon-driven mechanism. In terms of dexterity, the proposed hand achieved the highest score in the Kapandji test, fully reaching all ten reference positions, successfully completed all 33 grasp types defined in the GRASP taxonomy, and demonstrated effective in-hand manipulation capabilities. These results highlight the system’s strong potential for applications in dexterous robotic hands, prosthetic devices, and service robots.
Solar energy is one of the most widely used clean energy in human society. In order to improve the photoelectric conversion efficiency of solar energy, a variety of maximum power tracking methods for photovoltaic (PV) cells are proposed. Perturbation observation method (P&O) is one of the most commonly used methods for maximum power tracking. However, the conventional P&O cannot balance the tracking speed and tracking accuracy. Based on this, an improved P&O is proposed in this paper. At the same time, in order to facilitate the power tracking and control of PV cells system, a state-space oriented model of PV cells MPPT system is established in this paper, and recursive neural network (RNN) is used to complete the identification of model parameters. Simulation results show that the proposed P&O and the established state space model are effective. The results show that the improved P&O proposed in this paper can achieve rapid and accurate maximum power tracking of PV cells. At the same time, the state space model of MPPT system based on RNN has higher approximation accuracy to the original model.
1 September 2026 in IEEE Transactions on Fuzzy Systems