Cracks, potholes, and other defects often occur on infrastructure such as bridges, among which cracks are one of the most frequent defects. They have diverse shapes and are difficult to detect. Traditional manual inspection methods are inefficient and have low accuracy, while automated inspection machines are bulky and inconvenient to carry and use. Based on the shortcomings of existing detection technologies, this paper proposes a portable structural surface crack detection system based on the Android platform using a portable handheld image acquisition device. The system captures cracks on the structure's surface and obtains high-definition crack images. Then, these images are transmitted to portable smartphone terminals through Wi-Fi. Next, the image is pre-processed using weighted averaging, grayscale linear transformation, and adaptive median filtering. Then, the improved Canny edge detection algorithm is applied to identify crack information, and the edge segmentation algorithm is used to determine the crack width. Finally, based on camera calibration, the pixels are converted into the length data required for actual measurement. The results show that the system is easy to operate, and it not only has crack storage and tracking functions, but also can effectively measure the crack width on the surface of components. The measurement accuracy of this system reaches the sub-pixel level, and in actual testing, compared with the crack width gauge, the maximum relative error does not exceed 6.25%.
With the strict requirements of national policies on truck dimensions, axle loads, and weight limits, along with the implementation of tolls based on vehicle types, rapid and accurate identification of vehicle axle types has become essential for toll station management. To address the limitations of existing methods in distinguishing between drive and driven axles, complex equipment setup, and image evidence retention, this article proposes a panoramic image detection technology for vehicle chassis based on enhanced ORB and YOLOv11. A portable vehicle chassis image acquisition system, based on area array cameras, was developed for rapid on-site deployment within 20 min, eliminating the requirement for embedded installation. The FeatureBooster (FB) module was employed to optimize the ORB algorithm’s feature matching, and combined with keyframe technology to achieve high-quality panoramic image stitching. After fine-tuning the FB model on a domain-specific area scan dataset, the number of feature matches increased to 151 ± 18, substantially outperforming both the pre-trained FB model and the baseline ORB. Experimental results on axle type recognition using the YOLOv11 algorithm combined with ORB and FB features demonstrated that the integrated approach achieved superior performance. On the overall test set, the model attained an mAP@50 of 0.989 and an mAP@50:95 of 0.780, along with a precision (P) of 0.98 and a recall (R) of 0.99. In nighttime scenarios, it maintained an mAP@50 of 0.977 and an mAP@50:95 of 0.743, with precision and recall both consistently at 0.98 and 0.99, respectively. The field verification shows that the real-time and accuracy of the system can provide technical support for the axle type recognition of toll stations.
1 August 2025 in Wuhan University Journal of Natural Sciences
The quality of rebar welds directly impacts the overall service performance of highway infrastructure. However, current assessments of weld appearance quality primarily rely on traditional inspection methods such as manual visual inspection, which suffer from significant limitations in accuracy, reliability, and efficiency. Given the increasing demand for safety performance inspections of highway infrastructure in China, traditional methods struggle to meet modern rapid inspection requirements. Therefore, this study proposes the design of a portable, non-destructive inspection device for rebar weld appearance, utilizing visible light vision and line-structured light 3D scanning technology. The device is equipped with an STM32 master control chip to manage encoder reading, scanning laser control, ring fill light, industrial camera synchronization, image acquisition, and serial port command transmission. Additionally, a weld image processing and detection software system was developed to receive, store, and identify weld defects. A field inspection prototype was created and subjected to various defect weld detection experiments in a laboratory setting. Experimental results demonstrate that the device can accurately measure weld parameters by acquiring multimodal images, fulfilling defect detection requirements. The device features high detection accuracy, portability, and user-friendliness, making it significant for the objective inspection and evaluation of rebar weld appearance and welding quality.