Grating interferometry is an environmentally stable displacement measurement technique that has significant potential for identifying the position of the wafer stage. A fast and precise algorithm is required for real-time calculation of six degrees-of-freedom (DOF) displacement using phase shifts of interference signals. Based on affine transformation, we analyze diffraction spot displacement and changes in the internal and external effective optical paths of the grating interferometer caused by the displacement of the wafer stage (DOWS); then, we establish a phase shift-DOWS model. To solve the DOWS in real time, we present a polynomial approximation algorithm that uses the frequency domain characteristics of nonlinearities to achieve model reduction. The presented algorithm is verified by experiment and ZEMAX simulation.
In the displacement measurement of the wafer stage in lithography machines, signal quality is affected by the relative angular position between the encoder head and the grating. In this study, a two-degree-of-freedom fiber-coupled heterodyne grating interferometer with large operating range of rotation is presented. Fibers without fiber couplers are utilized to receive the interference beams for high-contrast signals under the circumstances of large angular displacement and ZEMAX ray tracing software simulation and experimental validation have been carried out. Meanwhile, a reference beam generated inside the encoder head is adopted to suppress the thermal drift of the interferometer. Experimental results prove that the proposed grating interferometer could realize sub-nanometer displacement measurement stability in both in-plane and out-of-plane directions, which is 0.246 nm and 0.465 nm of 3σ value respectively within 30 s.
Grating interferometers that use large two-dimensional grating splice modules for performing wide-range measurements have significant advantages for identifying the position of the wafer stage. However, the manufacturing process of large two-dimensional grating splice modules is very difficult. In contrast to existing redundant designs in the grating line dimension, we propose a novel interferometric reading head with a redundant design for obtaining wide-range displacement measurements. This interferometric reading head uses a one-dimensional grating splice module, and it was observed to be compatible with two orthogonal gratings. We designed a grating interferometer system composed of four reading heads to achieve a wide range of measurements and verified it using ZEMAX simulation. By conducting experiments, we were able to verify the compatibility of the reading head with gratings possessing different grating line directions; the measurement noise was found to be less than 0.3 nm.
13 September 2019 in International Journal of Precision Engineering and Manufacturing
In this paper, the errors of the displacement measurement interferometer with multi-mode fiber-coupled delivery are analyzed when the fibers are disturbed. Simulation results show that the characteristic frequency of the measurement error is consistent with that of disturbance, and the error has higher order frequency components. The experiments are designed for the effect of fringe contrast on the measurement error. The experimental results show that the measurement error is rather sensitive to the interference angle between the measurement arm and the reference arm in the multi-mode fibers, but not to the irradiance ratio of the measurement arm and the reference arm. In an interferometer with multimode fiber, the interference angle between the measurement arm and the reference arm needs to be restricted. This conclusion provides a theoretical basis for designing an interferometer measurement system with interference angle that is adaptive to wider application.
1 February 2021 in International Journal of Precision Engineering and Manufacturing