To achieve net-zero iron and steel production by 2050, many iron and steel producers are turning to direct reduced iron (DRI)—electric arc furnace (EAF) steel production as an opportunity to achieve significant CO2 emissions reductions relative to current levels. However, additional innovations are required to close the gap between DRI and net-zero steel. Pressurized chemical looping-DRI (PCL-DRI) is a novel technology explored to meet this target, in which the reformer firebox and fired process gas heaters are replaced with PCL combustion units. Captured CO2 is conditioned and compressed for pipeline transportation and storage/utilization. The performance of two different PCL-DRI configurations relative to traditional DRI processes was explored via process simulation: a Midrex-type process and an Energiron-type process. The PCL-DRI processes were shown to have equivalent or lesser total fuel consumption (8% reduction) compared to the base cases, and greater process water production (170–260% increase), with minimal or no loss in thermal efficiency. PCL-DRI is a strong competitor to alternative methods of reaching net-zero DRI due to lower energy penalties for carbon capture, no required changes to stream chemistry in or out of the EAF, and no requirement for hydrogen infrastructure.
The replacement of the blast furnace—basic oxygen furnace (BF-BOF) steelmaking route with the direct reduced iron—electric arc furnace (DRI-EAF) route reduces the direct CO2 emissions from steelmaking by up to 68%; however, the DRI shaft furnace is one of the largest remaining point source emitters in steelmaking. The capital and operating expenses of two potential nearly carbon-neutral DRI process configurations were investigated as a modification to a standard Midrex DRI facility. First, amine-based post-combustion capture with a 95% capture rate was considered as the benchmark, as it is currently commercially available. A second, novel configuration integrated the Midrex process with pressurized chemical looping—direct reduced iron (PCL-DRI) production. The capital expenditures were 71% and 28% higher than the standard Midrex process for a Midrex + amine capture plant, and a PCL-DRI plant, respectively. There was an incremental variable operating cost of USD 103 and USD 44 per tonne of CO2 for DRI production using amine capture and PCL-DRI, respectively. The amine capture configuration is most sensitive to the cost of steam generation, while PCL-DRI is more sensitive to the cost of electricity and the makeup oxygen carrier. An iron-based natural ore is recommended for PCL-DRI due to the low cost and availability. Based on the lower costs compared to amine-based post-combustion capture, PCL-DRI is an attractive means of eliminating CO2 emissions from DRI production.
To achieve net-zero emissions by the year 2050, carbon capture, utilization, and storage technologies must be implemented to decarbonize sectors with hard-to-abate emissions. Pressurized chemical looping (PCL) with a novel reactor design called a plug flow with internal recirculation (PFIR) fluidized bed is proposed as an attractive carbon capture technology to decarbonize small- and medium-scale emitters. The objective of this work is to examine the solid circulation rate between redox reactors in a cold flow chemical looping facility using an energy balance approach. The effects of static bed height, weir opening height, purge configuration, and gas flow rate on solid circulation rate were investigated. It was determined that parameters that greatly affected the total gas momentum, such as the fluidization ratio or number of purge rows, tended to also have a large effect on solid circulation rate. Parameters that had a small effect on total gas momentum, such as bed height, did not have a measurable effect on solid circulation rate. It was noted that parameters that posed a restriction to solids flow, such as a vertical purge jet or the weir itself, decreased the solid circulation rate compared to similar tests without restrictions.