Miroslaw Batentschuk

Dr. Miroslaw Batentschuk

Department of Materials Science and Engineering VI, Institute of Materials for Electronics and Energy Technology (i-MEET), University of Erlangen-Nürnberg, 91058 Erlangen, Germany

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 January 2016 in Energy & Environmental Science
Verified
Journal Article
Open access
PDF file
ILI. Levchuk
I. Levchuk
CWC. Würth
C. Würth
FKF. Krause
F. Krause
AOAndres Osvet
Andres Osvet
Miroslaw BatentschukMiroslaw Batentschuk
Miroslaw Batentschuk
CBC. J. Brabec
C. J. Brabec
We present colloidally stable and highly luminescent Zn x Cd 1–x S:Mn/ZnS core–shell nanocrystals (NCs) as cost-effective light converters for silicon photovoltaic (PV).

6 July 2021 in Crystals
Verified
Journal Article
Open access
PDF file
VGVitaliy Gorbenko
Vitaliy Gorbenko
TZTetiana E. Zorenko
Tetiana E. Zorenko
SWSandra Witkiewicz-Łukaszek
Sandra Witkiewicz-Łukaszek
ASAnna Shakhno
Anna Shakhno
AOAndres Osvet
Andres Osvet
Yuriy ZorenkoYuriy Zorenko
Yuriy Zorenko
This work is devoted to the crystallization and investigation of the optical properties of single crystalline films (SCFs) of Ce3+-doped Y3−xCaxAl5−ySiyO12 garnet, where the content of Ca2+ and Si4+ cations varied in the x = 0.13–0.52 and y = 0.065–0.5 ranges, respectively. The SCF samples were grown using the liquid phase epitaxy technique onto Y3Al5O12 substrates from the melt solution with equimolar Ca and Si content using PbO-B2O3 flux. However, the Ca and Si concentration in Y3−xCax Al5−ySiyO12:Ce SCFs is not equal: the Ca2+ content was systematically larger than that of Si4+, and the Ca2+ excess is compensated for by the Ce4+ ion formation. The absorption, scintillation, and luminescent properties of Y3−xCaxAl5−ySiyO12:Ce SCFs with different Ca/Si concentrations were investigated and compared with the sample of YAG:Ce SCF. Due to the creation of Ce4+ ions, the as-grown Y3−xCaxAl5−ySiyO12:Ce SCFs show relatively low light yield (LY) under α–particle excitation but a fast scintillation response with a decay time in the ns range. After SCF annealing in the reducing (N2 + H2) atmosphere at T > 1000 °C, the recharging of Ce4+→Ce3+ ions occurs. Furthermore, the samples annealed at 1300 °C SCF possess an LY of about 40% in comparison with the reference YAG:Ce SCF and scintillation decay kinetics much closer to that of the SCF counterpart. Due to Ca2+ and Si4+ alloying, the Ce3+ emission spectra in Y3−xCaxAl5−ySiyO12 SCFs are extended to the red range in comparison with the spectra of YAG:Ce SCF. Such an extension is caused by the Ce3+ multicenter formation at the substitutions of both Y3+ and Ca2+ dodecahedral positions in the hosts of these mixed garnets.

24 February 2023 in Materials
Verified
Journal Article
Open access
PDF file
VGVitaliy Gorbenko
Vitaliy Gorbenko
TZTetiana E. Zorenko
Tetiana E. Zorenko
ASAnna Shakhno
Anna Shakhno
PPPawel Popielarski
Pawel Popielarski
AOAndres Osvet
Andres Osvet
Yuriy ZorenkoYuriy Zorenko
Yuriy Zorenko
This research focuses on LPE growth, and the examination of the optical and photovoltaic properties of single crystalline film (SCF) phosphors based on Ce3+-doped Y3MgxSiyAl5−x−yO12 garnets with Mg and Si contents in x = 0–0.345 and y = 0–0.31 ranges. The absorbance, luminescence, scintillation, and photocurrent properties of Y3MgxSiyAl5−x−yO12:Ce SCFs were examined in comparison with Y3Al5O12:Ce (YAG:Ce) counterpart. Especially prepared YAG:Ce SCFs with a low (x, y < 0.1) concentration of Mg2+ and Mg2+–Si4+ codopants also showed a photocurrent that increased with rising Mg2+ and Si4+ concentrations. Mg2+ excess was systematically present in as-grown Y3MgxSiyAl5−x−yO12:Ce SCFs. The as-grown SCFs of these garnets under the excitation of α–particles had a low light yield (LY) and a fast scintillation response with a decay time in the ns range due to producing the Ce4+ ions as compensators for the Mg2+ excess. The Ce4+ dopant recharged to the Ce3+ state after SCF annealing at T > 1000 °C in a reducing atmosphere (95%N2 + 5%H2). Annealed SCF samples exhibited an LY of around 42% and similar scintillation decay kinetics to those of the YAG:Ce SCF counterpart. The photoluminescence studies of Y3MgxSiyAl5−x−yO12:Ce SCFs provide evidence for Ce3+ multicenter formation and the presence of an energy transfer between various Ce3+ multicenters. The Ce3+ multicenters possessed variable crystal field strengths in the nonequivalent dodecahedral sites of the garnet host due to the substitution of the octahedral positions by Mg2+ and the tetrahedral positions by Si4+. In comparison with YAG:Ce SCF, the Ce3+ luminescence spectra of Y3MgxSiyAl5−x−yO12:Ce SCFs greatly expanded in the red region. Using these beneficial trends of changes in the optical and photocurrent properties of Y3MgxSiyAl5−x−yO12:Ce garnets as a result of Mg2+ and Si4+ alloying, a new generation of SCF converters for white LEDs, photovoltaics, and scintillators could be developed.

1 June 2022 in Materials
Verified
Journal Article
Open access
PDF file
ASAnna Shakhno
Anna Shakhno
VGVitaliy Gorbenko
Vitaliy Gorbenko
TZTetiana E. Zorenko
Tetiana E. Zorenko
SWSandra Witkiewicz-Łukaszek
Sandra Witkiewicz-Łukaszek
YVYevheniya Vlasyuk
Yevheniya Vlasyuk
Yuriy ZorenkoYuriy Zorenko
Yuriy Zorenko
This work is dedicated to the crystallization and luminescent properties of a prospective Ca2YMgScSi3O12:Ce (CYMSSG:Ce) micropowder (MP) phosphor converter (pc) for a white light–emitting LED (WLED). The set of MP samples was obtained by conventional solid-phase synthesis using different amounts of B2O3 flux in the 1–5 mole percentage range. The luminescent properties of the CYMSSG:Ce MPs were investigated at different Ce3+ concentrations in the 1–5 atomic percentage range. The formation of several Ce3+ multicenters in the CYMSSG:Ce MPs was detected in the emission and excitation spectra as well as the decay kinetics of the Ce3+ luminescence. The creation of the Ce3+ multicenters in CYMSSG:Ce garnet results from: (i) the substitution by the Ce3+ ions of the heterovalent Ca2+ and Y3+ cations in the dodecahedral position of the garnet host; (ii) the inhomogeneous local environment of the Ce3+ ions when the octahedral positions of the garnet are replaced by heterovalent Mg2+ and Sc3+ cations and the tetrahedral positions are replaced by Si4+ cations. The presence of Ce3+ multicenters significantly enhances the Ce3+ emission band in the red range in comparison with conventional YAG:Ce phosphor. Prototypes of the WLEDs were also created in this work by using CYMSSG:Ce MP films as phosphor converters. Furthermore, the dependence of the photoconversion properties on the layer thickness of the CYMSSG:Ce MP was studied as well. The changes in the MP layer thickness enable the tuning of the white light thons from cold white/daylight to neutral white. The obtained results are encouraging and can be useful for the development of a novel generation of pcs for WLEDs.

30 June 2026 in Crystals
Verified
Journal Article
Open access
PDF file
Jack EliaJack Elia
Jack Elia
ATAlbert These
Albert These
CSChristian Schulbert
Christian Schulbert
APAmir Pourjafar
Amir Pourjafar
JZJiyun Zhang
Jiyun Zhang
Miroslaw BatentschukMiroslaw Batentschuk
Miroslaw Batentschuk
We show that halide evaporation during melt growth of CsPbBr3 on polycrystalline FTO under partially open conditions drives discrete phase selection between the line compounds of the CsBr–PbBr2 system, producing a sharp CsPbBr3/CsPb2Br5 bilayer instead of compositional grading. In situ optical imaging shows that solidification begins with nucleation and lateral growth of a planar CsPbBr3 single crystal while the melt layer is still thick enough to average over the FTO relief. As the crystal thickens, the residual melt then becomes inhomogeneous and unstable, producing a buried porous layer of faceted CsPb2Br5 grains with a characteristic in-plane spacing of 1–10μm). This morphology is consistent with a faceted Mullins–Sekerka-type instability under a non-conservative evaporative boundary condition. Beneath the single-crystal cap, the first-formed faceted islands are large and become progressively smaller as the advancing front approaches the FTO pyramids, while elevated ambient halide partial pressure suppresses the instability, consistent with diffusion–capillarity selection under decreasing residual melt thickness and steepening local gradients, modified by evaporative flux. Oxygen associated with microvoids or the oxide substrate enables a secondary reaction–diffusion pathway forming Pb–Br–O crystallites without altering the primary length scale. These results identify evaporation as an active control parameter coupling phase equilibria and interfacial stability in volatile halide melts. In the buried, porous bilayer morphology observed here, the secondary phases and porosity reduce the active CsPbBr3 volume and are expected to degrade scintillation through increased trapping, nonradiative recombination, and light scattering.