The interest and on-going research on utilisation of lignin as feedstock for production of renewable and sustainable aromatics is expanding and shows great potential. This study investigates the applicability of semi-continuously organosolv extracted lignin in Lignin-to-Liquid (LtL) solvolysis, using formic acid as hydrogen donor and water as solvent under high temperature–high pressure (HTHP) conditions. The high purity of the organosolv lignin provides high conversion yields at up to 94% based on lignin mass input. The formic acid input is a dominating parameter in lignin conversion. Carbon balance calculations of LtL-solvolysis experiments also indicate that formic acid can give a net carbon contribution to the bio-oils, in addition to its property as hydrogenation agent. Compound specific quantification of the ten most abundant components in the LtL-oils describe up to 10% of the bio-oil composition, and reaction temperature is shown to be the dominating parameter for the structures present. The structural and quantitative results from this study identify components of considerable value in the LtL-oil, and support the position of this oil as a potentially important source of building blocks for the chemical and pharmaceutical industry.
Methods for thermochemical conversion of biomass into renewable energy and materials rapidly increase in range and outreach. A focus on the target product streams for valorization is natural, yet several pretreatment steps and conversion methods also result in an aqueous byproduct, which has been given less attention. This paper aims to fill this knowledge gap in the existing literature on identification and quantification of organic components in such aqueous phases by reporting a fast and direct workup protocol combined with application of quantitative analytical nuclear magnetic resonance (NMR) spectroscopy. Laboratory workup procedures combined with subsequent proton NMR spectroscopy with water signal suppression using presaturation pulses during relaxation delay, noesygppr1d, have been established, evaluated, and approved by testing on three different Bruker BioSpin NMR spectrometers; an 850 MHz AVANCE III HD with a 5 mm TCI CryoProbe, a 600 MHz AVANCE NEO with a QCI CryoProbe, and a 500 MHz AVANCE with a 5 mm BBO room-temperature probe additionally confirmed the quantification method to be applicable. The analytical procedure identified furfural, methanol, acetic acid, and formic acid as the dominating compounds in the analyzed aqueous samples, which were process effluents generated by the patented Arbacore pellet production process using steam explosion of wood shavings. A selected range of quantitative results in the aqueous phase from large-scale steam explosion is included in the study. The described procedure provides excellent quantitative reproducibility with experimental series standard deviations of <1% (mM), is nondestructive, and can be automated on demand.
Sewage sludge contains active pharmaceutical ingredients (APIs) that persist after anaerobic digestion, posing challenges for its direct use as an organic amendment. This study presents a proof-of-concept investigation of the degradation of APIs through hydrothermal liquefaction (HTL), supporting the sustainability of using digested sewage sludge (DSS) as a feedstock for bio-oil production. In this work, the degradation of the four APIs carbamazepine, sertraline, telmisartan, and citalopram during HTL was investigated. Two experimental series were conducted at 330 °C for 4 h: one with APIs and formic acid only, and one with APIs, formic acid, and DSS. Formic acid was added to the reaction system as a hydrogen donor. Quantitative analyses of the organic product phases using GC–MS revealed complete degradation of all four APIs. The proposed degradation schemes provide detailed insights into the degradation pathways of the APIs during HTL, and the results suggest a greatly reduced likelihood of remaining pharmacological activity in the resulting products. These findings represent a significant step towards understanding and mitigating the risks associated with APIs in DSS and encourage further research to optimise the HTL process.