The optimization of the piston bowl design has been shown to have a great potential for air–fuel mixing improvement, leading to significant fuel consumption and pollutant emissions reductions for diesel engines. With this aim, a conventional re-entrant bowl for a 1.6 L light-duty diesel engine was compared with two innovative piston designs: a stepped-lip bowl and a radial-bumps bowl. The potential benefits of these innovative bowls were assessed through 3D-CFD simulations, featuring a calibrated spray model and detailed chemistry. To analyse the impact of these innovative designs, two different engine operating conditions were scrutinized, corresponding to the rated power and a partial load, respectively. Under the rated power engine operating condition, a start of injection sensitivity was then carried out to assess the optimal spray–wall interaction. Results highlighted that, thanks to optimal injection phasing, faster mixing-controlled combustion could be reached with both the innovative designs. Moreover, the requirements in terms of swirl were also investigated, and a higher swirl ratio was found to be necessary to improve the mixing process, especially for the radial-bumps design. Finally, at part-load operating conditions, different exhaust gas recirculation (EGR) rates were analysed for two injection pressure levels. The stepped-lip and radial-bumps bowls highlighted reduced indicated specific fuel consumption (ISFC) and soot emissions values over different rail pressure levels, guaranteeing NOx control thanks to the higher EGR tolerance compared with the re-entrant bowl. The results suggested the great potential of the investigated innovative bowls for improving efficiency and reducing emissions, thus paving the way for further possible optimization through the combination of these designs.
29 December 2024 in International Journal of Engine Research
Nowadays the use of Hydrogen (H2) within Internal Combustion Engine (ICE) represents a valuable solution also for high-performance applications since it allows carbon free combustion process preserving, at the same time, the driving experience of the engines fuelled with conventional fuels. On the other side, the low ignition energy and the high flammability range may lead to a high probability of abnormal combustion events especially at high engine loads. Therefore, this work aims at investigating the occurrence of knock and pre-ignition phenomena in a high-performance Direct Injection (DI) single cylinder Spark Ignition (SI) engine through the synergistic use of numerical simulations and experimental activities. A 3D-CFD model was calibrated against a set of experimental measurements. The engine model showed satisfactory predictive capabilities with a good matching with the experimental in-cylinder pressure traces. This virtual test rig was then used to investigate the impact of a different coolant temperature and different injector recess in terms of knock and pre-ignition tendency, and most of all, to define a robust simulation methodology to estimate the risk of hydrogen abnormal combustion events.