Laser additively manufactured duplex stainless steels contain mostly ferrite in the as-built parts due to rapid solidification of the printed layers. To achieve duplex microstructures (ferrite and austenite in roughly equal proportions) and, thus, a good combination of mechanical properties and corrosion resistance, an austenitic stainless steel powder (X2CrNiMo17-12-2) and a super duplex stainless steel powder (X2CrNiMoN25-7-4) were mixed in different proportions and the powder mixtures were processed via PBF-LB/M (Laser Powder Bed Fusion) under various processing conditions by varying the laser power and the laser scanning speed. The optimal process parameters for dense as-built parts were determined by means of light optical microscopy and density measurements. The austenitic and ferritic phase formation of the mixed alloys was significantly influenced by the chemical composition adjusted by powder mixing and the laser energy input during PBF-LB/M. The austenite content increases, on the one hand, with an increasing proportion of X2CrNiMo17-12-2 in the powder mixtures and on the other hand with increasing laser energy input. The latter phenomenon could be attributed to a slower solidification and a higher melt pool homogeneity with increasing energy input influencing the phase formation during solidification and cooling. The desired duplex microstructures could be achieved by mixing the X2CrNiMo17-12-2 powder and the X2CrNiMoN25-7-4 powder at a specific mixing ratio and building with the optimal PBF-LB/M parameters.
24 September 2025 in Progress in Additive Manufacturing
Additive manufacturing of pure copper is of interest due to the materials thermal and electrical conductivity, corrosion resistance and ductility, as well as the possibility of creating value through the production of complex structures. Powder bed fusion of copper using an electron beam (PBF-EB) is considered promising due to the vacuum atmosphere, the scalable beam power, and the high reflectivity of copper for IR radiation used in state-of-the-art powder bed fusion of metals using a laser beam (PBF-LB/M) machines. In PBF-EB, spot-based exposure strategies are considered a promising approach to overcome issues resulting from vector-based processing with variable vector length such as lack of fusion, local temperature accumulation, and surface swelling. However, the processing of pure copper using spot-based exposure strategies is widely uncovered. This study investigates the transfer of exposure parameters from vector- to spot-based processing of pure copper and compares the relative density, microstructure and physical properties. Both applied exposure strategies yielded relative densities exceeding 99.5%, electrical conductivities exceeding 100% IACS, and thermal diffusivities above 1.17 cm 2 s −1 . Variations in microstructure and mechanical properties are analyzed using electron backscatter diffraction method and attributed to differences in local thermal gradients and solidification speed. The results indicate that, in addition to conventional vector-based exposure strategies, spot-based exposure approaches are also applicable for the fabrication of complex components.