Gas sensors applied in real-time detection of toxic gas leakage, air pollution, and respiration patterns require a reliable test platform to evaluate their characteristics, such as sensitivity and detection limits. However, securing reliable characteristics of a gas sensor is difficult, owing to the structural difference between the gas sensor measurement platform and the difference in measurement methods. This study investigates the effect of measurement conditions and system configurations on the sensitivity of two-dimensional (2D) material-based gas sensors. Herein, we developed a testbed to evaluate the response characteristics of MoS2-based gas sensors under a NO2 gas flow, which allows variations in their system configurations. Additionally, we demonstrated that the distance between the gas inlet and the sensor and gas inlet orientation influences the sensor performance. As the distance to the 2D gas sensor surface decreased from 4 to 2 mm, the sensitivity of the sensor improved to 9.20%. Furthermore, when the gas inlet orientation was perpendicular to the gas sensor surface, the sensitivity of the sensor was the maximum (4.29%). To attain the optimum operating conditions of the MoS2-based gas sensor, the effects of measurement conditions, such as gas concentration and temperature, on the sensitivity of the gas sensor were investigated.
1 November 2020 in Journal of the Korean Physical Society
This paper reports the results of a passivation study of InAs/GaSb type-II strained layer superlattice for a mid-wave infrared detector with p-on-n polarity. The cutoff wavelength of the fabricated photodiode was observed to be 5.5 mu m at 77 K. At a negative bias of 0.1 V, the dark current density was measured to be 2.8 x 10(-5), 8.2 x 10(-5), and 3.1 x 10(-2) A/cm(2) for the diodes passivated with SiO2 and Si3N4 and the unpassivated diode, respectively. The photodiode passivated with SiO2 demonstrated a reduction in dark current density of approximately three times than that of the diode passivated with Si3N4. Therefore, the dynamic resistance-area product of the photodiode under the negative bias, passivated with SiO2, showed a larger value than that of the device passivated with Si3N4. In contrast, at 100-150 K, the resistance-area product at the zero-bias voltage of the photodiode passivated with Si3N4 showed a higher value than that of the device passivated with SiO2. It is believed that the relatively low thermal stress between GaSb and Si3N4 reduced the dark current density at zero bias and increased R(0)A in this temperature range.
26 February 2019 in Journal of the Korean Physical Society
This paper reports the results of modeling of optical and electrical characteristics of InAs/GaSb type II strained layer superlattice (SLS) for the mid-wave infrared detection with n-on-p polarity....
20 April 2021 in Journal of the Korean Physical Society
The dark current of a type-II InAs/GaSb strained layer superlattice photodiode with an n-i-p structure is reduced by using an active gate bias technique. To make the gate structure on the mesa sidewall of the photodiode, we used Si3N4 and Ti/Au as a dielectric film and a gate metal, respectively. At 77 K, the dark current density of the photodiode with a gate bias (VG = −30 V) applied on the mesa side wall is reduced by more than one order of magnitude compared to the dark current density at zero gate bias. At 77 K, the product of the dynamic differential resistance and the area at a gate bias of −30 V shows a 12 times improvement compared to the same measurement at zero gate bias.
1 February 2018 in Journal of the Korean Physical Society
We fabricated a flexible white light emitting device by mixing a fabricated zinc sulphide (ZnS) composite (ZnS: Al, Cu, Mn) and polydimethylsiloxane (PDMS) between the thin silver plastic electrodes....