Significant efforts are being put into the development of efficient micrometer-scale light emitting diodes (LEDs) for future display technologies due to their marked benefits over existing displays. To date, however, the efficiency of microLED devices remains significantly lower than that of conventional broad-area devices. The deterioration in device performance with smaller device size has been linked to the plasma damage induced on mesa sidewalls during device fabrication. Here, we studied bottom-up red-emitting nanowire LEDs with different Mg doping levels in the p-GaN layer. The resulting sub-micron LED devices show a distinct improvement in efficiency with increasing Mg dopant incorporation. Through optimization of the doping, we measured an external quantum efficiency of ∼8.3% and a wall-plug efficiency of ∼4.6%, at a current density of ∼1 A/cm2, for a red-emitting sub-micrometer scale LED operating at >630 nm. This study highlights the importance of p-doping in microLEDs for attaining high efficiency performance in nanostructure-based devices.
MXene's two-dimensional (2D) morphology, metallic electrical conductivity, and optical transparency characteristics have been widely utilized to uplift the performance of diverse optoelectronic devices. In this study, we demonstrate a simple spin-coating of 2D MXene nanosheets on 1D GaN nanorods (NRs) to establish a van der Waals (vdW) Schottky junction, which is efficient to detect UV radiation (λ = 382 nm) without requiring the external power supply. The built-in electric field developed through vdW Schottky junction formation stimulates the separation of electron–hole pairs and thereby facilitates the MXene/GaN NRs device to exhibit better UV detection performance than the pristine GaN NRs device. The performance of both pristine GaN and MXene/GaN NRs devices is compared by tuning the UV radiation power density in the range of 0.33–1.35 mW/cm2. Notably, the self-powered MXene/GaN NRs photodetector demonstrated the characteristics of high photoresponsivity (48.6 mA/W), detectivity (5.9 1012 Jones), and external quantum efficiency (543%). These characteristics signify the suitability of MXene/GaN self-powered photodetectors for various applications, including imaging, sensing networks, and energy-saving communication.
N-polar AlGaN is an emerging wide-bandgap semiconductor for next-generation high electron mobility transistors and ultraviolet light emitting diodes and lasers. Here, we demonstrate the growth and characterization of high-quality N-polar AlGaN films on C-face 4H-silicon carbide (SiC) substrates by molecular beam epitaxy. On optimization of the growth conditions, N-polar AlGaN films exhibit a crack free, atomically smooth surface (rms roughness ∼ 0.9 nm), and high crystal quality with low density of defects and dislocations. The N-polar crystallographic orientation of the epitaxially grown AlGaN film is unambiguously confirmed by wet chemical etching. We demonstrate precise compositional tunability of the N-polar AlGaN films over a wide range of Al content and a high internal quantum efficiency ∼74% for the 65% Al content AlGaN film at room temperature. Furthermore, controllable silicon (Si) doping in high Al content (65%) N-polar AlGaN films has been demonstrated with the highest mobility value ∼65 cm2/V-s observed corresponding to an electron concentration of 1.1 × 1017 cm−3, whereas a relatively high mobility value of 18 cm2/V-s is sustained for an electron concentration of 3.2 × 1019 cm−3, with an exceptionally low resistivity value of 0.009 Ω·cm. The polarity-controlled epitaxy of AlGaN on SiC presents a viable approach for achieving high-quality N-polar III-nitride semiconductors that can be harnessed for a wide range of emerging electronic and optoelectronic device applications.
Exploring highly efficient and stable photoelectrode material is essential for high-performance photoelectrochemical (PEC) water-splitting applications. III-nitride semiconductors, particularly InGaN, have been considered as prospective materials for PEC hydrogen evolution. However, their surface states and other recombination centers, which enhance the charge recombination kinetics, are bottlenecks for the high PEC performance. In this work, we report the construction of type-II heterojunction by sputter depositing SnO2 on InGaN nanorods (NRs) to promote interfacial carrier transport and thereby enhance PEC performance. The energy band offsets at the SnO2/InGaN NRs interface were analyzed by x-ray photoelectron spectroscopy. Type-II heterojunction was defined at the SnO2/InGaN NRs interface with a valence band offset of 0.77 eV and conduction band offset of 0.25 eV. The photocurrent density of the SnO2/InGaN NRs photoanode is 7.09 mA/cm2 at 0.77 V vs Ag/AgCl electrode with 80 nm SnO2 thickness, which is ∼14-fold higher than that of the pristine InGaN NRs photoanode. Furthermore, the applied bias photo-to-current efficiency of SnO2/InGaN NRs photoanode records 3.36% at 0.77 V vs Ag/AgCl electrode. The enhanced PEC performance is mainly ascribed to the formation of high-quality SnO2/InGaN NRs heterojunction that enforces the directional charge transfer and substantially boosts the separation of photogenerated electron–hole pairs at the interface of InGaN NRs and SnO2. Overall, this work sheds light on the promising strategy to design and fabricate III-nitride nanostructures-based photoelectrodes for feasible PEC water-splitting applications.
16 May 2024 in Physical Chemistry Chemical Physics
Establishing a heterostructure is one of the adequate strategies for enhancing device performance and has been explored in sensing, and energy applications. We designed p-CuO/n-InGaN NRs excellent H 2 S gas sensing performance at room temperature.
To date, the performance of AlGaN-based mid and deep ultraviolet (UV) light-emitting diodes (LEDs) is limited by the presence of a high density of defects, quantum-confined Stark effect, inefficient doping, and optical polarization transition from transverse electric to transverse magnetic mode in high Al-content AlGaN quantum wells. In this study, we address some of these fundamental challenges by utilizing monolayer (ML) GaN active regions in AlGaN-based UV LEDs. We show, both theoretically and experimentally, that charge carrier recombination occurs predominantly via the excitonic transition in ML GaN active regions, wherein the exciton binding energy exceeds 0.12 eV. We further demonstrate that double ML UV LEDs emitting at 300 nm exhibit an external quantum efficiency and a wall-plug efficiency of 5.6% and 3.5%, respectively, with excellent spectral stability.