Molecular dynamics simulations have been used to investigate the coupling process between plasticity and structural phase transformation in single-crystal iron under both shock and ramp compressions. In both cases, iron was found to yield via twinning. Then, the onset of the bcc-hcp phase transformation was shown to be tightly dependent on the plasticity history through a hardening-like effect, which in some conditions may inhibit the nucleation of the hcp phase.
In this article, we investigate the kinetics of the iron transition under laser-driven ramp compression for deformation rates ranging from 3 to . As in previous work, we observe a plateau in the rear surface velocity profile at the transition. With increasing deformation rate the transition onset pressure raises from 11 to 25 GPa, while the plateau duration decreases. These kinetic effects are well reproduced by an Avrami-type kinetics model of nucleation and growth with a constant, nanosecond scale completion time, which suggests an isokinetic regime over the explored range of strain rates.
Nonequilibrium molecular dynamics simulations have been used to investigate phase transformations and plasticity in single-crystal iron from shock compression to dynamic tension and subsequent spall fracture. In consistence with experimental observations, the unloading wave following the compression front is found to evolve into a rarefaction shock at the reverse hexagonal-close-packed to body-centered-cubic (bcc) phase transformation, and a pressure hysteresis between the direct and reverse phase transformations is evidenced. The interaction of this unloading wave with the rarefaction wave reflected from the sample free surface classically induces tension within the crystal, which is found to drive a bcc to face-centered-cubic (fcc) phase transformation in agreement with very recent experimental observation under subnanosecond laser shock loading. At the atomic scale, the mechanism governing this bcc to fcc phase transformation is consistent with a Bain transformation path. The spall fracture process is observed to occur through voids nucleation and growth either at favorable sites (twin boundaries, bcc-fcc grain boundaries after partial transformation) or within the defect-free fcc crystal (after full transformation). Thus, the spall strength increases with the fcc phase fraction near the plane of maximum tension. An amorphous microstructure is observed around the voids, likely due to significant heating upon severe plastic deformation, in consistence with experimental clues from the literature.
Efficient laser shock processing of materials requires a good characterization of their dynamic response to pulsed compression, and predictive numerical models to simulate the thermomechanical processes governing this response. Due to the extremely high strain rates involved, the kinetics of these processes should be accounted for. In this paper, we present an experimental investigation of the dynamic behavior of iron under laser driven ramp loading, then we compare the results to the predictions of a constitutive model including viscoplasticity and a thermodynamically consistent description of the bcc to hcp phase transformation expected near 13 GPa. Both processes are shown to affect wave propagation and pressure decay, and the influence of the kinetics of the phase transformation on the velocity records is discussed in details.
Non-equilibrium molecular dynamics simulations have been used to investigate strain-rate dependence of plasticity and phase transition in [001]-oriented single-crystal iron under ramp compression. Here, plasticity is governed by deformation twinning, in which kinetics is tightly correlated with the loading rate. Over the investigated range of strain rates, a hardening-like effect is found to shift the onset of the structural bcc-to-hcp phase transformation to a high, almost constant stress during the ramp compression regime. However, when the ramp evolves into a shock wave, the bcc–hcp transition is triggered whenever the strain rate associated with the plastic deformation reaches some critical value, which depends on the loading rate, leading to a constitutive functional dependence of the transition onset stress on the plastic deformation rate, which is in overall consistence with the experimental data under laser compression.