Based on hybrid wavelength pumping and tapered Yb-doped fibers (T-YDFs), a 650 W all-fiber single-frequency polarization-maintaining fiber amplifier was demonstrated experimentally at 1030 nm. Different pump power ratios in the T-YDF-based power-amplifier stage were proposed to investigate their influence on the transverse mode instability (TMI) effect. The highest TMI threshold was obtained when the pump power ratio of 940 nm to 976 nm was 1:4.4. A measured M2 factor of 1.7 and a polarization extinction ratio of 14 dB at the maximum output power were obtained. To the best of our knowledge, these results exhibit the highest output power of any all-fiber single-frequency polarization-maintaining fiber amplifiers created up to now.
A 1560 nm high-power linearly-polarized all-fiber single-frequency narrow-linewidth laser with near diffraction-limited beam quality is demonstrated. The Yb–Er energy transfer efficiency and the ability of the signal laser to capture pump light have been improved by specifically choosing the pumping wavelength and the input signal power in the final power amplifier stage of this laser system. Under the off-peak absorption pumping wavelength of 940 nm, along with the maximum input signal power of 6 W, a maximum output power of 102 W with a slope efficiency of 40.5% is acquired. At the highest output power status, a polarization extinction ratio (PER) of 15.5 dB, a linewidth of 3.05 kHz, and a beam quality of Mx2 = 1.14, My2 = 1.06 are obtained, respectively. This advanced single-frequency fiber laser has great potential for the long-range coherent Doppler lidar and the next generation of gravitational wave detection.
In this study, a kilowatt-level high-efficiency narrow-linewidth all-fiber Tm3+-doped continuous-wave laser operating at 1.95 μm is demonstrated. Benefitting from an advanced boost design of a two-stage main amplifier, it not only effectively manages heat dissipation resulting from the high pump-induced quantum defect but also realizes the controlled extraction of optical gain and improves the optical conversion efficiency. Finally, this laser system has realized an output power of 1018 W, a linewidth of 3.8 GHz, and a slope efficiency of 60.0% simultaneously. Moreover, a high optical signal-to-noise ratio of over 45 dB and excellent beam quality of M2 factors 1.19 are obtained. To the best of our knowledge, this represents the narrowest linewidth and highest slope efficiency achieved in a kilowatt-level Tm³⁺-doped fiber laser. Such a high-performance laser is ideally suited for mid-infrared generation and remote sensing applications.
An over-20-octaves-bandwidth ultralow-intensity-noise 1064-nm single-frequency fiber laser (SFFL) is demonstrated based on a comprehensive all-optical technique. With a joint action of booster optical amplifier (BOA) and reflective Yb-doped fiber amplifier (RYDFA), two-fold optical gain saturation effects, respectively occurring in the media of semiconductor and fiber, have been synthetically leveraged. Benefiting from the gain dynamics in complementary time scales, i.e., nanosecond-order carrier lifetime in BOA and millisecond-order upper-level lifetime in RYDFA, the relative intensity noise (RIN) is reduced to −150 dB/Hz from 0.2 kHz to 350 MHz, which exceeds 20-octaves bandwidth. Remarkably, a maximum suppressing ratio of >54 dB is obtained, and the RIN in the range of 0.09–10 GHz reaches −161 dB/Hz which is only 2.3 dB above the shot-noise limit. This broad-bandwidth ultralow-intensity-noise SFFL can serve as an important building block for squeezed light generation, space laser communication, space gravitational wave detection, etc.
A pulse compressing technology of single-frequency Q-switched laser based on the cascaded four-wave mixing (CFWM) effect is demonstrated theoretically and experimentally, for the first time to the best of our knowledge. A theoretical model of the pulse compression is established through deconstructing the pulse duration evolution in the high-order Stokes and anti-Stokes lights of CFWM. A pulse compression ratio of (2|m|+1)1/2 is quantificationally obtained with m corresponding to the order number of the CFWM light. Utilizing dual-wavelength (DW) single-frequency Q-switched laser injected into a highly nonlinear fiber (HNLF), the pulse compression and the spectral broadening phenomenon are observed simultaneously. As the order number of the CFWM light increases from 0-order to 3-order, the pulse duration has reduced from 115 ns to 47 ns with a compression ratio of 2.45, which is essentially consistent with the theoretical analysis. The pulse compressing technique by CFWM is conducive to promoting the performance development of the single-frequency Q-switched laser, which can improve the system precision in the Lidar, trace gas detection, and high-precision ranging. Furthermore, this technology based on time-frequency transformation dynamics may be generally applicable to other single-frequency pulsed fiber lasers.