A multi-step annealing method was successfully applied to inclusions reduction and resistivity improvement of CdMnTe:In (CMT:In) single crystals with high resistivity, including a Cd atmosphere annealing step followed by a Te atmosphere annealing step. After the Cd atmosphere annealing step, the density of Te inclusions was reduced distinctly, and it could be also decreased in the subsequent step of re-annealing under Te atmosphere. Both the resistivity and IR transmittance decreased notably after Cd atmosphere annealing, whereas they increased tremendously after re-annealing under a Te atmosphere. The reduction of full-width at-half-maximum (FWHM) and the increase of the intensity of the X-ray rocking curve indicated an improvement of the crystal quality. Meanwhile, after Cd atmosphere annealing, the increase of the intensity of the (D0,X) peak and the disappearance of the (A0,X) peak in photoluminescence (PL) measurements suggested further that the crystal quality was improved. The detector performance was enhanced obviously after annealing. The higher the annealing temperature, the better the performance was. The detector fabricated by CMT:In slice (Cd atmosphere annealing at 1073 K for 240 h and Te atmosphere re-annealing at 773 K for 120 h) with 9.43% energy resolution and 1.25 × 10−3 cm2/V μτ value had the best detector performance.
The implementation of SiC fiber reinforced SiC/SiC composites to aero-engine hot components has attracted wide attention, due to their many excellent properties. Along these lines, in order to predict the oxidation behavior of the material in extreme environments and to explore the effect of different preforms on the oxidative behavior of the composites, four SiC/SiC composites, with different preforms, were oxidized under environmental conditions of pressure of 12 kPa H2O:8 kPa O2:80 kPa Ar, at 1400 °C temperature. Moreover, the morphology and defect distribution of the samples were characterized by carrying out scanning electron microscopy, and micro-computed X-ray tomography measurements. Furthermore, the relation between the micro- and macro-scales was established, so as to be able to predict the oxidation behavior of the composites; not only the quantitative relationship between the mass change rate and the defect volume change rate, but also the combination of micro-computed X-ray images.
High−performance bolts made of carbon/carbon (C/C) composites are necessary for connecting thermally−insulating structural components of aerospace vehicles. To enhance the mechanical properties of the C/C bolt, a new silicon infiltration−modified C/C (C/C−SiC) bolt was developed via vapor silicon infiltration. The effects of silicon infiltration on microstructure and mechanical properties were systematically studied. Findings reveal that dense and uniform SiC−Si coating has been formed after silicon infiltration of the C/C bolt, strongly bonding with the C matrix. Under tensile stress, the C/C−SiC bolt undergoes a tensile failure of studs, while the C/C bolt is subject to the pull−out failure of threads. The breaking strength of the former (55.16 MPa) is 26.83% higher than the failure strength of the latter (43.49 MPa). Under double−sided shear stress, both the crushing of threads and the shear failure of studs occur within two bolts. As a result, the shear strength of the former (54.73 MPa) exceeds that of the latter (43.88 MPa) by 24.73%. According to CT and SEM analysis, matrix fracture, fiber debonding, and fiber bridging are the main failure modes. Therefore, a mixed coating formed by silicon infiltration can effectively transfer loads from coating to carbon matrix and carbon fiber, thereby enhancing the load−bearing capacity of C/C bolts.