To investigate the flotation separation behavior of petalite and quartz, various methods were employed in this study. These included micro-flotation experiments, a contact angle analysis, zeta potential analysis, Fourier transform infrared spectroscopy (FTIR), and X-ray photoelectron spectroscopy (XPS) to explore the separation mechanism of a modified ether amine reagent (L0-503) for petalite and quartz under weakly alkaline conditions. The micro-flotation test results indicated that the modified ether amine collector had a higher collecting ability for quartz than for petalite, with a maximum recovery rate of 93.2% for quartz and a recovery rate consistently below 14% for petalite in the presence of L0-503. This indicates that the modified ether amine reagent can be used as a reverse flotation agent for separating petalite and quartz. The separation mechanism results showed that the modified ether amine reagent had a significantly higher adsorption capacity for quartz than for petalite due to a strong reaction between the quartz and the secondary amine (-NH=) on the modified ether amine collector. Additionally, the electrostatic force and hydrogen bonding between the reagent and quartz further enhanced the adsorption, while no reaction occurred between the reagent and petalite.
A micro–nanobubble generator is the most critical component of micro–nano flotation equipment. Understanding the bubble generation characteristics in the generator plays a vital role in optimizing the performance of the device and improving the flotation of fine-grained minerals. In this study, to explore the generation and evolution of bubbles in the micro–nanobubble generator of a cyclonic jet flotation cell, the flow field parameters of the gas–liquid two-phase flow inside the generator were solved using CFD–PBM combined with Luo’s population balance model. The internal bubble size was in the range of 0.99 μm to 140 μm. After the gas entered the generator from the suction pipe, it mainly moved in the center of the tube, and the diameter of the bubbles was relatively large at this time. With the bubble movement, large bubbles in the center were broken into small bubbles and then moved toward the periphery of the tube. Thereafter, the smaller-diameter bubbles gathered and formed large-diameter bubbles. The average diameter of the generated bubbles gradually increased from approximately 30 to 110 μm.