The detonation engine, which can produce high specific impulse during the underwater detonation process (UDP), has become the forefront of underwater propulsion. In this paper, the thrust mechanism conducted in UDP and the propagation characteristics of the complex pressure waves are numerically studied, and the correlation between those two features is analyzed. The thrust from UDP is generated in a submerged detonation tube (SDT) and driven by the stoichiometric methane-oxygen mixture. The results show that detonation of the pre-filled combustible gas mixture gives rise to complex pressure waves and delivers several force impulses to the SDT. The impulses present different effects on the thrust performance, which is divided into two stages. In the first stage, before the detonation wave collides with the exterior water, the thrust is provided by the persistent back pressure effect of the detonation product. When the detonation wave propagates through the SDT exit and strikes the gas–water interface, a transmitted shock wave and a reflected shock wave are formed, which produce the impulses dominating the second stage. The reflected shock wave eventually impinges on the inner wall, imposing a force impulse on it. The pressure disturbance on the annular wall caused by the transmitted shock wave and subsequent detonation gas jet leads to another two thrust impulses. Finally, a comparison between the thrust of the SDT and its counterpart in the air is conducted to characterize the influence of UDP, and the effects of dimensional parameters of the SDT are also investigated.
Fill fraction not only has a profound impact on the process of deflagration to detonation in pulsed detonation engine, but also affects the propulsion performance in both flight and ground tests. In this paper, a novel optical diagnostic method based on detonation exhaust radiation in visible and near-infrared region within 300–2600 nm is developed to determine the current working state in the gas–liquid two-phase pulsed detonation cycle. The results show that the radiation characteristic in each stage of detonation cycle is unique and can be a good indicator to infer the fill fraction. This is verified experimentally by comparison with the laser absorption spectroscopy method, which utilizes a DFB laser driven by ramp injection current to scan H2O transition of 1391.67 nm at a frequency of 20 kHz. Due to concentrated radiation intensity, time duration reaching accumulated radiant energy ratio of 50% in detonation status would be smaller than 1.2 ms, and detonation status would be easily distinguished from deflagration with this critical condition. In addition, the variation of important intermediates OH, CH, and C2 radicals during detonation combustion are obtained according to the analysis of detonation spectrum, which can also be proposed as a helpful optical diagnostics method for the combustion condition based on C radical concentration. The study demonstrates the feasibility of optical diagnostics based on radiation in visible and near-infrared regions, which could provide an alternative means to diagnose and improve pulsed detonation engine performance.
7 October 2021 in International Journal of Turbo & Jet-Engines
In order to study the influence of different nozzle configurations on the gas–liquid two-phase pulse detonation engine (PDE) propulsion performance, the measurement system based on the tunable diode laser absorption spectroscopy (TDLAS) technology is built to measure the velocity and the temperature, while the high frequency dynamic pressure sensor is used to measure the nozzle gas pressure. Based on the momentum principle, the contribution mechanism of unsteady gas jet on thrust is obtained indirectly by TDLAS data. The results show that the impulses of PDE with non-nozzle, convergent nozzle, divergent nozzle and convergent–divergent nozzle are 1.95, 2.08, 1.85 and 2.16 N∙s within 20 ms of the exhaust period, respectively. The analysis reveals that the impulses of PDE with convergent and convergent–divergent nozzles are larger than that with non-nozzle, while the impulse of PDE with divergent nozzle is smaller than that with non-nozzle. The research results in this paper can provide reference for the design of nozzles for PDE.