Solar heating technology has the advantages of being high efficiency, energy-saving, and environment protecting; however, the instability of solar energy and its mismatch with the variation characteristics of building heat load have caused great difficulties in the design and the efficient operation strategy of a solar system. A heat storage tank is an important part of a solar hot water system. In order to improve system efficiency, this paper proposes a flat plate PCM storage tank, establishes a mathematical model, and conducts experimental verification under different working conditions. Experiments show that in the heat storage process, the phase change material (PCM) only accounts for less than 20% of the space of the PCM storage tank, and its heat storage can reach 50% of the total heat storage of the tank. In the discharge process, the water temperature of the ordinary tank decreases by 20 °C within 1.5 h, and the phase change process lasts approximately 3 h, with the water temperature remaining at 45~50 °C during this period. In the natural cooling process, the heat discharge of the two water tanks at night was similar, while the temperature of the ordinary water tank decreased by 12 °C and that of the phase change water tank decreased by 7 °C. By simulating the dynamic simulation model of the composite solar phase change thermal storage combined with an air-cooled heat pump system, the results show that the solar heating system with a PCM storage tank (SHS-PCM) saves 34% more energy than a solar heating system with a common tank (SHS-without PCM), and the volume of the PCM storage tank is reduced to 1/5 of the ordinary tank. The investment payback period method of energy saving reconstruction is used to analyze the economy of the SHS-PCM and the SHS-without PCM, the initial investment cost of the SHS-PCM is CNY 9858 higher than the SHS-without PCM, but the annual operation cost is saved by CNY 12,100, and the project investment payback period is 0.81 years, which has energy-saving potential and economic benefits.

The variability and inhomogeneity of solar energy limits the development of solar heating systems (SHS) in many fields. In order to improve the utilization efficiency of SHS, this paper takes three typical cities (Xi’an, Dunhuang, Lhasa) as the research object, studies the operation state of SHS in student dormitory buildings, and puts forward a corresponding optimization strategy. The research shows that the reduction of water supply temperature will improve the operation efficiency and energy saving effect of a spontaneous combustion heat pump and that there is an optimal volume of heat storage water tank (HSWT), which can make the energy saving effect of SHS run better. The optimization of the SHS shows the water supply temperature is 35 °C, and the optimal volume of HSWT is 15 m³ in the “Resource-general area (Ⅲ)” represented by Xi’an, 25 m³ in the “Resource-rich area (Ⅱ)” represented by Dunhuang, and 40 m³ in the “Resource-richer area (Ⅰ)” represented by Lhasa. With the increase in the abundance of solar energy resources in the region, the optimal volume of HSWT also increases. Meanwhile, the solar energy contribution rate of the three regions in descending order is 61.3% (Lhasa), 32.8% (Dunhuang), and 25.9% (Xi’an). After optimization, the contribution of SHS increased by about 5%. The research results will help improve the efficiency of SHS in cold areas of China and make the system more efficient and energy efficient during operation.

The instability of solar energy and its resource distribution characteristics make it difficult to judge its suitability in practical engineering applications, which hinders its promotion and application. In order to better promote the effective use of solar energy and promote the solar heating system, it is necessary to put forward a simple method of judging the suitability of the solar heating system for engineering application. This study puts forward “F, Q” as the basis for judging the suitability of solar heating systems built on the roof. Two types of public buildings, office buildings and three-star hotels, are taken as the research objects. DeST software is used to change the heating area of the building by superimposing floors to simulate the heat load of the building when the heating area changes. A dynamic simulation coupling model of solar heating system is established in the TRNSYS software to analyze the operating status of the system under all working conditions. The functional relationship between “F, Q” and solar energy guarantee rate is established, and the solar energy contribution rate is divided into three regions of F < 30%, 30% ≤ F ≤ 50%, and F > 50%. The evaluation standard of the building suitability of the solar energy heating system is established according to the scope of “F, Q” in different regions (An office building for, e.g., if the contribution rate of solar heating system is required to be greater than 50%, the “F” of these four areas should be greater than 0.11388, 0.15543, 0.10572, and 0.04511.), and the effectiveness of “F” is verified through actual cases verified by other scholars in the research. The method proposed in this paper is helpful to judge the suitability of solar heating systems in different regions and different types of conventional buildings, so as to better promote solar heating systems.