We found that the extrinsic inductance shows a strong bias dependence in GaN high-electron mobility transistors (HEMTs) based on a conventional small-signal equivalent circuit, with a decreasing value as current increases. This abnormal behavior not only complicates the parameter extraction, but also indicates potential invalidity of formulations for the extrinsic inductance, leading to a parameter value of less physical meaning. By introducing a novel intrinsic resistance along with an inductance in the equivalent circuit, the bias dependence of extrinsic elements can be inhibited, and a high precision fit between simulation and measurement can be achieved for GaN HEMTs with a gate length of 0.1 μm up to 65 GHz.
This letter presents a hybrid series-shunt LC tank matching technique, which constructs an imaginary-impedance part for impendence (power) matching and cancels the imaginary-impedance deviations caused by the aggravated load and parasitic effects in millimeter-wave (mm-wave) high-frequency band, allowing broadband simultaneous noise and impedance matching (BSNIM) for mm-wave CMOS low-noise amplifier (LNA). The proposed matching network has been synthesized into a triple-coupled transformer-based matching network further to enable a compact and robust solution in differential circuit design. To validate the proposed BSNIM techniques, an $E$ / $W$ -band LNA is fabricated with 40-nm CMOS, and achieves less than $-$ 10 dB S11 from 58 to 110 GHz and a low noise figure (NF) of 4.2–6.9 dB from 58 to 100 GHz. The peak gain of the LNA is 16.4 dB at 85 GHz with a 3-dB gain bandwidth (BW) from 70 to 91 GHz, while consuming 20.7 mW from 0.9-V supply.
5 May 2022 in IEEE Microwave and Wireless Components Letters
This letter presents a convenient approach based on the two-port kQ-product theory to analyze the influence of interwinding capacitive coupling on the efficiency of the transformer. It is demonstrated that a transformer with proper size can benefit from the interwinding capacitive coupling to maximize its efficiency at a desired frequency. The proposed design approach is used in a W-band low-noise amplifier (LNA) fabricated with the 40-nm CMOS process to optimize the insertion loss of the input transformer-based balun. Thanks to the approach, the W-band LNA achieves a minimum noise figure of 5.7 dB, a maximum gain of 18.5 dB, and a 3-dB bandwidth of 76.5-92.6 GHz, while consuming 23.4 mW from a 0.9-V supply.
This paper presents the design of a low noise amplifier in 0.13-μm CMOS technology. The conventional inductive degeneration is applied to reduce the noise figure. The amplifying stage uses the cascode structure to increase the gain and achieve a better isolation. Operated at 1.2V, the simulated gain of the LNA is better than 20 dB while the noise figure is less than 1.8 dB with the bandwidth from 5 GHz to 6 GHz. The core size of the fully-integrated CMOS LNA circuit is 680μm*800μm.