Displacement piles are driven to support a wide range of structures. Predicting their axial limiting capacities and load-displacement behavior is critical to many such engineering applications. Although field load tests may be conducted to check design assumptions, such tests can prove expensive and difficult to generalize. Numerical analyses undertaken to support design face uncertainty over the potentially important effects of pile installation because no well-developed method exists to predict the stresses applying during and after driving. Recent experiments have provided evidence regarding the stresses and strains developed around displacement piles during installation in sand that can help guide representative numerical modeling. This paper contributes to this development by reporting large displacement numerical analyses and linking these to high-quality experiments. The arbitrary Lagrangian–Eulerian (ALE) options available in ABAQUS 2016/Explicit have been employed to simulate highly instrumented calibration chamber tests made with closed-ended piles penetrated into sand. Predictions for the stress components developed during and after pile installation are presented, along with measurements made by other authors of the corresponding strain fields. The simulations’ broad agreement with the available experimental evidence indicates that the adopted ALE technique and soil modeling approach are appropriate for pile installation analysis in sands.
The microbial-induced carbonate precipitation (MICP) technique has been increasingly employed for erosion mitigation and stabilization of sandy slopes. Biocementation can improve the strength and stiffness of unsaturated sand. In this study, the performance of a new biogrouting method (i.e., surface percolation) for sandy slopes under unsaturated conditions was investigated. Model-scale laboratory tests were conducted on MICP-treated coastal slopes to assess the erosion resistance to wave actions. The spatial distribution of in the biocemented sandy slope was measured, which can reveal the mechanism and characteristics of biocementaion of sandy slopes. Results show that the slope surface experienced no obvious erosion after the implementation of MICP treatment for four cycles. The lowest degree of saturation was observed at the slope crest, and it increased to the highest value at the slope toe. Similarly, the erosion resistance was also doubled from the slope crest to the slope toe due to flow of water/solution in the slope in the downward direction.
1 March 2018 in Journal of Geotechnical and Geoenvironmental Engineering
The paper presents a new mechanism-based two-step approach for assessing spudcan penetration resistance in three-layer stiff-soft-stiff clay sediments. An alternative approach is also proposed, establishing a direct correlation between spudcan and cone penetration resistances. The approaches are developed based on the results from a parametric study through large-deformation finite-element analyses and validated against centrifuge test data and a case history. These can be taken as a “top-down” approach. The bearing capacities are evaluated at the seabed, at the depth of maximum bearing capacity in the first (stiff) layer, at the depth of triggering squeezing in the second (soft) layer, and at the second–third layer interface successively, followed by the estimation of the penetration resistance profile in the third (stiff) layer. For the mechanism-based approach, design formulae are also proposed for assessing the limiting cavity depth, variation of the soil plug height, and equivalent undrained shear strength of the second layer that accounts for the effect of the third layer. The depth of triggering squeezing in the second layer is estimated through an iterative approach to incorporate the effect of the soil plug trapped beneath the advancing spudcan, which leads to earlier squeezing. For the alternative approach, design correlations are established between cone tip and spudcan penetration resistances. A direct comparison between the estimated profiles using the proposed design approaches and the “bottom-up” approach recommended in the current international design standard confirms the benefit of using the former.