Reservoir silting is an unavoidable issue. It is estimated that in Italy, the potential rate of silting-up in large reservoirs ranges from 0.1% to 1% in the presence of wooded river basins and intensive agricultural land use, respectively. In medium and small-sized reservoirs, these values vary between 0.3% and 2%. Considering both the types of reservoirs, the annual average loss of storage capacity would be of about 1.59%. In this paper, a management strategy aimed at sediment productive reuse is presented. Particularly, the main engineering outcomes of an extensive experimental program on geopolymer binder synthesis is reported. The case study deals with Occhito reservoir, located in Southern Italy. Clay sediments coming from this silted-up artificial lake were characterized, calcined and activated, by means of a wide set of alkaline activating solutions. The results showed the feasibility of this recovery process, optimizing a few chemical parameters. The possible reuse in building material production (binders, precast concrete, bricks, etc.) represents a relevant sustainable alternative to landfill and other more consolidated practices.
This paper proposes a methodological approach to the re-use of reservoir sediments for coastal nourishment. The proposed approach represents a point of convergence between water and sediment management, coastal protection from erosion and the re-use of sediments dredged from reservoirs. In particular, this study indicates a general protocol of actions and a reference legislative scenario for the use of sediment from reservoirs for beach nourishment as an alternative to sediment from sea caves or land caves. Quantitative characterization of reservoir sediments and their qualitative characterization are the fundamental steps to define the compatibility between reservoir sediment and beach sand. The study was applied to a real case of Southern Italy known as the Guardialfiera Reservoir.
Greenhouse gas emission is one of the main environmental issues of today, and energy savings in all industries contribute to reducing energy demand, implying, in turn, less carbon emissions into the atmosphere. In this framework, water pumping systems are one of the most energy-consuming activities. The optimal regulation of pumping systems with the use of variable speed drives is gaining the attention of designers and managing authorities. However, optimal management and operation of pumping systems is often performed, employing variable speed drives without considering if the energy savings are enough to justify their purchasing and installation costs. In this paper, the authors compare two optimal pump scheduling techniques, optimal regulation of constant speed pumps by an optimal ON/OFF sequence and optimal regulation with a variable speed pump. Much of the attention is devoted to the analysis of the costs involved in a hypothetical managing authority for the water distribution system in order to determine whether the savings in operating costs is enough to justify the employment of variable speed drives.
In recent years, the interest towards the use of pumps operating as turbines (PATs) for the generation of electrical energy has increased, due to the low cost of implementation and maintenance. The main issue that inhibits a wider use of PATs is the lack of corresponding characteristic curves, because manufacturers usually provide only the pump-mode performance characteristics. In the PAT selection phase, the lack of turbine-mode characteristic curves forces users to expend expensive and time-consuming efforts in laboratory testing. In the technical literature, numerous methods are available for the prediction of PAT turbine-mode performance based on the pump-mode characteristics, but these models are usually calibrated making use of few devices. To overcome this limit, a performance database called Redawn is presented and the data collected are used to calibrate novel PAT performance models.
Erosive processes influence on several phenomena. In particular, they could influence on land depletion, on vegetation weakening, on aggradation phenomena of intermediate, and plain reaches of rivers, on waterways interruption due to overaggradation phenomena caused by floods, and on the losses of water volumes that may be stored in reservoirs. Among the models proposed in the literature for the prediction of erosion on the annual scale, one of the most widely used is the Revised Universal Soil Loss Equation (RUSLE). In the present paper, starting from the definition of the original model, the authors improved the important combined slope length and slope angle (LS-factor), taking into account the mutual interaction of solid particles, in terms of path and confluences, so as to transform the model, which was first classified on a slope scale or at most on a parcel one, into a distributed model on a basin scale. The use of a distributed approach is an integral part of the analysis of the hydrogeological risk. In this way, it is possible to obtain a map of the erodibility of any basin, from which to derive the most vulnerable areas. The proposed methodology has been tested on the Camastra Basin, located in Basilicata Region of Southern Italy.