In this study, the effects of graphene oxide (GO) on composites based on epoxy resin were analyzed. Different contents of GO (1.5–6vol.%) were added to epoxy resin. The GO/epoxy composite was prepared using the casting method and was prepared under room temperature. Mechanical tests’ results such as tensile test, impact test and hardness test show enhancements of the mechanical properties of the GO/epoxy composite. The experimental results clearly show an improvement in the Young’s modulus, tensile strength and hardness. The impact strength was seen to decrease, pointing to brittleness increase of the GO/epoxy composite. A microstructure analysis using Scanning Electron Microscopy (SEM) and X-ray diffraction (XRD) analysis was also performed, which showed how GO impeded the propagation of cracks in the composite. From the SEM images we observed the interface between the GO and the epoxy composite. As can be seen from this research, the GO/epoxy composites can be used for a large number of applications. The results of this research are a strong evidence for GO/epoxy composites being a potential candidate for use in a variety of industrial applications, especially for automobile parts, aircraft components, and electronic parts such as supercapacitors, transistors, etc

This study aims to investigate the influence of building height and layout on energy consumption. It also analyzes methods for reducing energy consumption in these buildings. The EnergyPlus software performs simulations under local climatic conditions for all seasons. The city is divided into several sections based on cardinal directions, and energy consumption is calculated for each section, considering the city's distinct seasonal variations. Buildings in suburban areas with more sunlight exhibited higher overall energy consumption due to the reliance on heating and cooling systems, compared to the city center where denser urban areas moderated temperature extremes. Additionally, building design and insulation played significant roles. The analysis also revealed a west-to-east trend; higher consumption at the edges compared to the center. This is attributed to factors such as building density and shade from taller structures. The study further examined the impact of varying building heights. While most buildings were 20 meters tall, specific rows ranged from 21 to 25 meters. Changing these heights resulted in decreased cooling and increased heating demands in the north-south analysis, and reduced demands for both heating and cooling in the west-east analysis. This highlights the complex interplay between building layout, height, and energy consumption.