Observation‐based and modeling studies have identified the Eastern Mediterranean and Middle East (EMME) region as a prominent climate change hotspot. While several initiatives have addressed the impacts of climate change in parts of the EMME, here we present an updated assessment, covering a wide range of timescales, phenomena and future pathways. Our assessment is based on a revised analysis of recent observations and projections and an extensive overview of the recent scientific literature on the causes and effects of regional climate change. Greenhouse gas emissions in the EMME are growing rapidly, surpassing those of the European Union, hence contributing significantly to climate change. Over the past half‐century and especially during recent decades, the EMME has warmed significantly faster than other inhabited regions. At the same time, changes in the hydrological cycle have become evident. The observed recent temperature increase of about 0.45°C per decade is projected to continue, although strong global greenhouse gas emission reductions could moderate this trend. In addition to projected changes in mean climate conditions, we call attention to extreme weather events with potentially disruptive societal impacts. These include the strongly increasing severity and duration of heatwaves, droughts and dust storms, as well as torrential rain events that can trigger flash floods. Our review is complemented by a discussion of atmospheric pollution and land‐use change in the region, including urbanization, desertification and forest fires. Finally, we identify sectors that may be critically affected and formulate adaptation and research recommendations toward greater resilience of the EMME region to climate change.

The Liwa area is a primary food production area in the United Arab Emirates (UAE) and has intensively been used for agriculture. This study investigates the pollution levels with heavy metals in agricultural soils from the Liwa area. Thirty-two soil samples were analyzed for Mn, Zn, Cr, Ni, Cu, Pb, Cd, Co, and As. Results revealed that heavy metal levels varied in the ranges 220.02–311.21, 42.39–66.92, 43.43–71.55, 32.86–52.12, 10.29–21.70, 2.83–8.84, 0.46–0.69, 0.03–0.37 mg/kg for Mn, Zn, Cr, Ni, Cu, Pb, Cd, Co, and As, respectively. All samples presented low As concentrations with an average of 0.01 mg/kg. The variations in bulk metal contents in the soil samples were related to multiple sources, including agrochemicals, atmospheric dust containing heavy metals, and traffic-related metals. Enrichment factor analysis indicates that Cd, Ni, Zn, and Cr were highly enriched in soils, and they could originate from non-crustal sources. Based on the geo-accumulation index (I_geo), the soil samples appeared uncontaminated with Mn, Cr, Zn, Pb, Co, As, Cu, uncontaminated to moderately contaminated with Ni and moderately contaminated with Cd. The contamination factors suggest low contamination, except for Ni, which showed moderate contamination. The average pollution load index (PLI) revealed unpolluted to low pollution of all soil samples. The ecological risk assessment (PERI) showed that all heavy metals posed a low risk, except for Cd which exhibited a high ecological risk.

The captivating attributes of carbon nanotubes (CNT) comprising chemical and mechanical steadiness, outstanding electrical and thermal conductivities, featherweight, and physiochemical consistency make them coveted materials in the manufacturing of electrochemical devices. Keeping in view such exciting features of carbon nanotubes, our objective in the present study is to examine the flow of aqueous based nanofluid comprising single and multi-wall carbon nanotubes (CNTs) past a vertical cone encapsulated in a permeable medium with convective heat and solutal stratification. The impacts of heat generation/absorption, gyrotactic-microorganism, thermal radiation, and Joule heating with chemical reaction are added features towards the novelty of the erected model. The coupled differential equations are attained from the partial differential equations by exercising the local similarity transformation technique. The set of conservation equations supported by the associated boundary conditions are worked out numerically by employing bvp4c MATLAB function. The sway of numerous appearing parameters in the analysis on the allied distributions is scrutinized and the fallouts are portrayed graphically. The physical quantities of interest including Skin friction coefficient, the rate of heat and mass transfers are assessed versus essential parameters and their outcomes are demonstrated in tabulated form. It is witnessed that the velocity of the fluid decreases for boosting values of the magnetic and suction parameters in case of both nanotubes. Moreover, the density of motile microorganism is decreased versus larger estimates of bio-convection constant. A notable highlight of the presented model is the endorsement of the results by matching them to an already published material in the literature. A venerable harmony in this regard is achieved.

The aim of this study was twofold. Firstly, we performed a land capability class determination of the agricultural soils from the Abu Dhabi Emirate, the United Arab Emirates, based on the concentrations of 17 chemical elements determined in the soil samples collected from 84 locations. Secondly, we assess the soil pollution with different metals, using several pollution indices. The results of Principal Component Analysis (PCA) shows that four principal components (PCs) are responsible for describing the total metals concentrations’ variance, the highest contribution on PC1 being that of Mn, and Cr, on PC2 that of Fe, on PC3 that of Cu, and on PC4 that of Al. After determining the optimal number of clusters, we classified the sites into three clusters, while the studied metals were grouped function on their concentrations. Then, we used five indices to assess the pollution level of the soil at the study sites and in the clusters. The geo—accumulation index (I_geo) indicates uncontamination/moderately contamination with Cu in cluster 1, uncontaminated/moderately contaminate soils with Cd, Cu, and Ni in cluster 2, and uncontaminated/moderately contaminated soil with Cu and moderately contaminated with Pb, Zn, and Ni in cluster 3. By comparison, the enrichment factors overestimate the pollution of the studied sites. The pollution load index (PLI) indicates a baseline level of pollution at 14 sites and the deterioration of the soil quality at four sites. The Nemerow pollution index provides similar results as PLI.

This study aims to scrutinize the thin film flow of a nanofluid comprising of carbon nanotubes (CNTs), single and multi-walled i.e., (SWCNTs and MWCNTs), with Cattaneo-Christov heat flux and entropy generation. The time-dependent flow is supported by thermal radiation, variable source/sink, and magneto hydrodynamics past a linearly stretched surface. The obtained system of equations is addressed by the numerical approach bvp4c of the MATLAB software. The presented results are validated by comparing them to an already conducted study and an excellent synchronization in both results is achieved. The repercussions of the arising parameters on the involved profiles are portrayed via graphical illustrations and numerically erected tables. It is seen that the axial velocity decreases as the value of film thickness parameter increases. It is further noticed that for both types of CNTs, the velocity and temperature distributions increase as the solid volume fraction escalates.

Prosopis species were introduced to the United Arab Emirates (UAE) region for desert greening. However, the species now pose a great threat to the native plant diversity. This study used high-resolution satellite imagery (1990–2019) to understand the history and current distribution of Prosopis species and their impact on fresh groundwater. The results show that the Prosopis invasion in the study area reached its maximum expansion rate in 2019 and covered an area of about 16 km² compared to 0.2 km² in 1990. The areas near Sharjah Airport, Umm Fannan, and Al Talla, located at a lower elevation of the sand dune area, are heavily invaded. Prosopis groundwater requirement derived using evapotranspiration shows that groundwater consumption has changed drastically after 2010 and consumed about 22.22 million m³ of groundwater in 2019, which is about a 7372% increase in groundwater consumption from the year 1990 to 2019. The results can be useful for setting up a management plan for the sustainable use of this species in the UAE region in particular and other similar countries in the arid land regions that are suffering from freshwater depletion because of Prosopis invasion.