Tailorable synthesis of III-V semiconductor heterostructures in nanowires (NWs) enables new approaches with respect to designing photonic and electronic devices at the nanoscale. We present a comprehensive study of highly controllable self-catalyzed growth of gallium phosphide (GaP) NWs on template-free silicon (111) substrates by molecular beam epitaxy. We report the approach to form the silicon oxide layer, which reproducibly provides a high yield of vertical GaP NWs and control over the NW surface density without a pre-patterned growth mask. Above that, we present the strategy for controlling both GaP NW length and diameter independently in single- or two-staged self-catalyzed growth. The proposed approach can be extended to other III-V NWs.
Controlled growth of heterostructured nanowires and mechanisms of their formation have been actively studied during the last decades due to perspectives of their implementation. Here, we report on the self-catalyzed growth of axially heterostructured GaPN/GaP nanowires on Si(111) by plasma-assisted molecular beam epitaxy. Nanowire composition and structural properties were examined by means of Raman microspectroscopy and transmission electron microscopy. To study the optical properties of the synthesized nanoheterostructures, the nanowire array was embedded into the silicone rubber membrane and further released from the growth substrate. The reported approach allows us to study the nanowire optical properties avoiding the response from the parasitically grown island layer. Photoluminescence and Raman studies reveal different nitrogen content in nanowires and parasitic island layer. The effect is discussed in terms of the difference in vapor solid and vapor liquid solid growth mechanisms. Photoluminescence studies at low temperature (5K) demonstrate the transition to the quasi-direct gap in the nanowires typical for diluted nitrides with low N-content. The bright room temperature photoluminescent response demonstrates the potential application of nanowire/polymer matrix in flexible optoelectronic devices.
In this paper we study theoretically influence of group 3 and group 5 deposition rates on A3B5 nanowires (NWs) self-catalyzed vapor–liquid–solid (VLS) growth. Our self-consistent approach allows numerical calculation of chemical potential difference of the growth species, group 5 atomic concentration in the droplet and NW elongation rate for two-component system depending on deposition rates. It is found that chemical potential difference tends to saturation with increasing group 5 deposition rate (J5), while increase of group 3 deposition rate (J3) leads to its logarithmic growth. Two growth regimes are distinguished depending on relation between the deposition rates: high J3 and low J5 leads to adsorption-limited NW growth and in the opposite case nucleation-limited regime occurs. Nanowire elongation rate increases linearly with group 3 deposition rate in nucleation-limited regime. Further increase of the deposition rate leads to saturation of the growth rate in adsorption-limited regime. On the contrary, elongation rate grows linearly with group 5 deposition rate in adsorption-limited regime with slower linear growth in nucleation-limited regime.
Wurtzite GaP nanowires are interesting for the direct bandgap engineering and can be used as templates for further growth of hexagonal Si shells. Most wurtzite GaP nanowires have previously been obtained with Au catalysts. Here, we show that long (∼500 nm) wurtzite sections are formed in the top parts of self-catalyzed GaP nanowires grown by molecular beam epitaxy on Si(111) substrates in the droplet consumption stage, which is achieved by abruptly increasing the atomic V/III flux ratio from 2 to 3. We investigate the temperature dependence of the length of wurtzite sections and show that the longest sections are obtained at 610 °C. A supporting model explains the observed trends using a phase diagram of GaP nanowires, where the wurtzite phase is formed within a certain range of the droplet contact angles. The optimal growth temperature for growing wurtzite nanowires corresponds to the largest diffusion length of Ga adatoms, which helps to maintain the required contact angle for the longest time.
Control and analysis of the crystal phase in semiconductor nanowires are of high importance due to the new possibilities for strain and band gap engineering for advanced nanoelectronic and nanophotonic devices. In this letter, we report the growth of the self-catalyzed GaP nanowires with a high concentration of wurtzite phase by molecular beam epitaxy on Si (111) and investigate their crystallinity. Varying the growth temperature and V/III flux ratio, we obtained wurtzite polytype segments with thicknesses in the range from several tens to 500 nm, which demonstrates the high potential of the phase bandgap engineering with highly crystalline self-catalyzed phosphide nanowires. The formation of rotational twins and wurtzite polymorph in vertical nanowires was observed through complex approach based on transmission electron microscopy, powder X-ray diffraction, and reciprocal space mapping. The phase composition, volume fraction of the crystalline phases, and wurtzite GaP lattice parameters were analyzed for the nanowires detached from the substrate. It is shown that the wurtzite phase formation occurs only in the vertically-oriented nanowires during vapor-liquid-solid growth, while the wurtzite phase is absent in GaP islands parasitically grown via the vapor-solid mechanism. The proposed approach can be used for the quantitative evaluation of the mean volume fraction of polytypic phase segments in heterostructured nanowires that are highly desirable for the optimization of growth technologies.
GaN nanowires were grown using selective area plasma-assisted molecular beam epitaxy on SiOx/Si(111) substrates patterned with microsphere lithography. For the first time, the temperature–Ga/N2 flux ratio map was established for selective area epitaxy of GaN nanowires. It is shown that the growth selectivity for GaN nanowires without any parasitic growth on a silica mask can be obtained in a relatively narrow range of substrate temperatures and Ga/N2 flux ratios. A model was developed that explains the selective growth range, which appeared to be highly sensitive to the growth temperature and Ga flux, as well as to the radius and pitch of the patterned pinholes. High crystal quality in the GaN nanowires was confirmed through low-temperature photoluminescence measurements.