We show that the mode locking in coupled circle maps with random phases is very different from that in a single circle map. A finite nonlinearity is needed for a step to appear. The width of the step behaves as (K- . The complete mode locking (at K=1 for uncoupled maps) behaves singularly as the coupling is turned on. We argue that our model describes the mode locking in charge-density-wave materials. Our results are in qualitative agreement with the experimental observation by Sherwin and Zettl that only few true steps exist in the I-V characteristics and that in addition to these there are some ‘‘incomplete’’ steps.
28 March 2011 in IEEE Transactions on Instrumentation and Measurement
Accurate knowledge of the input impedance of a radio-frequency identification (RFID) integrated circuit (IC) at its wake-up power is valuable as it enables the design of a performance-optimized tag for a specific IC. However, since the IC impedance is power dependent, few methods exist to measure it without advanced equipment. We propose and demonstrate a wireless method, based on electromagnetic simulation and threshold power measurement, applicable to fully assembled RFID tags, to determine the mounted IC's input impedance in the absorbing state, including any parasitics arising from the packaging and the antenna-IC connection. The proposed method can be extended to measure the IC's input impedance in the modulating state as well.
The equations of motion of the symmetrical dc superconducting quantum interference device (SQUID) are numerically investigated with a 16-term Taylor-expansion routine. The coherent phase or single-junction state is found to be unstable in large regions of the phase space including areas of interest in magnetometer design. The stability problem is discussed analytically in terms of the Hill equation. Feigenbaum sequences to chaos are found at borders of stability of various types of solution. Some of these, at finite external fluxes, occur at quite physical values of SQUID parameters.
1 May 2012 in Nordic Pulp & Paper Research Journal
The key operation in tissue production is the creping at the Yankee cylinder. The tissue sheet is adhered to a Yankee cylinder and then detached from the surface with a blade. As a result a strong microstructure - crepe folds - is generated on the web. In this work the structure of creping pattern in CD and MD of tissue paper was studied. The samples available in this work consisted of bath tissue and towel grades. The significant difference between the samples was in the number of crepe folds. The tissue sheets were analyzed with an imaging system. The variation of crepe folds in images was studied in spatial frequency space through 2D Welch spectrum. It was noticed that the difference in creping pattern structure between the samples can be seen clearly in spectra. The creping pattern was simulated based on the creping pattern variation found from the Welch spectra of tissue paper images. The simulation was based on a set of sinusoidal terms representing several orientations and amplitudes. The amplitudes of sinusoidal terms located in regular grid in spectra were approximated with 2D normal distribution. Thus, the structure of creping pattern can be represented with three parameters originating from the deviations and location of 2D normal distribution. The creping pattern reconstructed with simulations contains the relevant features in the creping pattern of true tissue images.