Mohammed Gatte

Dr. Mohammed Gatte


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2016 in Progress In Electromagnetics Research M
Verified
Journal Article
Open access
PDF file
MGMohammed Gatte
Mohammed Gatte
Ping Jack SohPing Jack Soh
Ping Jack Soh
HRHasliza A. Rahim
Hasliza A. Rahim
RARaad Badlishah Ahmad
Raad Badlishah Ahmad
FMFareq Malek
Fareq Malek
The improvement of Terahertz (THz) antenna requires efficient (nano)materials to operate within the millimeter wave and THz spectrum. In this paper, doped graphene is used to improve the performance of two types of patch antennas, a rectangular and an elliptical antenna. The surface conductivity of conventional (non-doped) graphene is first modeled prior to the design and simulation of the two graphene based antennas in an electromagnetic solver. Next, different graphene models and their corresponding surface conductivities are computed based on different bias voltages or chemical doping. These configurations are then benchmarked against a similar antenna based on conventional metallic (copper) conductor to quantify their levels of performance improvement. The graphene based antennas showed significant improvements for most parameters of antenna than that of the conventional antenna. Besides that, the higher chemical potentials resulting from higher biasing voltages also resulted in this trend. Finally, the elliptical patch graphene antenna indicated better reflection performance, radiation efficiency and gain than a rectangular patch operating at the same resonant frequency.

1 February 2023 in International Journal of Electrical and Computer Engineering (IJECE)
Verified
Journal Article
Open access
PDF file
AHAhmed A. Hamad
Ahmed A. Hamad
MGMohammed Gatte
Mohammed Gatte
LALaith Ali Abdul-Rahaim
Laith Ali Abdul-Rahaim
In this paper, an efficient early termination (ET) mechanism for systematic turbo-polar code (STPC) based on optimal estimation of scaling factor (SF) is proposed. The gradient of the regression line which best fits the distance between a priori and extrinsic information is used to estimate the SF. The multiplication of the extrinsic information by the proposed SF presents effectiveness in resolving the correlation issue between intrinsic and extrinsic reliability information traded between the two typical parallel concatenated soft-cancellation (SCAN) decoders. It is shown that the SF has improved the conventional STPC by about 0.3 dB with an interleaver length of 64 bits, and about 1 dB over the systematic polar code (SPC) at a bit error rate (BER) of . A new scheme is proposed as a stopping criterion, which is mainly based on the estimated value of SF at the second component decoder and the decoded frozen bits for each decoding iteration. It is shown that the proposed ET results in halving the average number of iterations (ANI) without adding considerable complexity. Moreover, the modified codes present comparable results in terms of BER to the codes that utilize fix number of iterations.

30 June 2021 in International Journal of Numerical Modelling: Electronic Networks, Devices and Fields
Verified
Journal Article
Closed access
PDF file
MGMohammed Gatte
Mohammed Gatte
Ping Jack SohPing Jack Soh
Ping Jack Soh
RKRasim Azeez Kadhim
Rasim Azeez Kadhim
HAHaider J. Abd
Haider J. Abd
RAR. Badlishah Ahmad
R. Badlishah Ahmad

1 February 2024 in Bulletin of Electrical Engineering and Informatics
Verified
Journal Article
Open access
PDF file
AAAlaa Hamzah Abdullah
Alaa Hamzah Abdullah
KAKarrar M. Al-Anbary
Karrar M. Al-Anbary
QHQasim Mahdi Hamad
Qasim Mahdi Hamad
HAHanaa M A Mohsin Ali Alabboodi
Hanaa M A Mohsin Ali Alabboodi
MGMohammed Gatte
Mohammed Gatte
Since renewable energy sources (RES) have almost little inertia, an increase in their electricity might harm the power system's ability to run steadily and dependably. Numerous solutions to the issue mentioned above are offered. This paper aims to assess the technological possibility of using energy storage system (ESS) devices built from batteries and supercapacitors to enhance the interia response of sources in microgrids with a large amount of PV power penetration. The microgrid's inertia was altered by varying the penetration level of RES. To obtain a rigid microgrid, batteries and supercapacitors are suggested in this study to enhance frequency stability and droop control is utilized to complete this assessment. The model of the on-grid power network was designed using Simulink in MATLAB to evaluate the high level of RES penetration impact on the frequency stability of the system. Results verify that the microgrid stiffness is significantly enhanced when the suggested storage elements are incorporated. The findings show that the rate of change of frequency (RoCoF) is reduced when the size of the ESS increases and vice versa. The supercapacitor energy storage system (SCESS) can increase the stability of the system's frequency more effectively than the battery energy storage systems (BESS) with a slower time response.

1 June 2022 in Bulletin of Electrical Engineering and Informatics
Verified
Journal Article
Open access
PDF file
AHAhmed Abdulkadhim Hamad
Ahmed Abdulkadhim Hamad
HAHaider Saheb Al-Mumen
Haider Saheb Al-Mumen
MGMohammed Gatte
Mohammed Gatte
This paper proposed an experimental device that emulates and facilitates teaching the theoretical concepts of error-control coding (ECC) techniques. Two prototypes laboratory boards were designed and implemented. The first board simulates the transmitter side of a typical digital communication system. It mainly contains a data source, (7,4) Hamming encoder, cyclic redundancy check encoder (CRC), and Gaussian noise generator. The second board has two types of Hamming decoders, a syndrome decoder, and a maximum likelihood (ML) decoder that accepts the received soft signals at the channel output. Each board has several control switches so that the trainee can change the code variables, noise power, user ID, in addition to display tools such as light-emitting diodes (LEDs), and test points for the oscilloscope that help the user to observe the results. Moreover, results and setting variables can also be displayed on a PC’s screen connected through a USB port and organic light emitting diodes (OLED) display that is attached to the receiver board. The pipelining architecture of the field programmable gate array (FPGA) device was exploited in this proposed system to reduce the processing delay and hence increase the data throughput. Furthermore, we proved that both theoretical and experimental tests are identical.

1 February 2021 in Journal of Physics: Conference Series
Verified
Conference Paper
Open access
PDF file
MGMohammed Gatte
Mohammed Gatte
PSPing Jack Soh
Ping Jack Soh
RKRasim Azeez Kadhim
Rasim Azeez Kadhim
HAH. J. Abd
H. J. Abd
The transfer of graphene onto dielectric substrates to form an antenna needs to be performed with care, as tears and cracks may appear on the samples transferred improperly. This paper studies a detailed method in estimating the performance of a millimeter-wave (MMW) antenna built using commercially-available graphene layers. In contrast to the widely studied monolayer graphene, the proposed antenna is produced based on the chemical vapor deposition (CVD) technique, which is to be secured onto the antenna substrate via adhesive material without removal of the transition metal substrate from the graphene layer sample. The antenna performance modeled using this technique indicated quite similar results to a model using ideal monolayer graphene in terms of gain, radiated power and radiation efficiency. Its performance benchmarked against a copper antenna operating at the same MMW frequency also indicated similar performance improvements as with another antenna designed using monolayer graphene.