To improve the efficiency of cable force adjustment of composite saddle anchor span of single-tower single-span ground-anchored suspension bridge, a strain incremental adjustment method is proposed. The analytical calculation model is established according to the relative spatial position of the cable strand and the saddle groove of the composite saddle, and the target cable force of the cable strands is calculated by the target position of the composite saddle in the cable-stayed bridge and construction phases. Considering the coupling relationship between the cable strand and the composite saddle, the calculation formula of the change in main span main cable force and anchor span cable force after the adjustment of a single cable strand is derived. Based on the condition of equilibrium of forces along the slip surface of the composite saddle, the slip amount of composite saddle after a round of cable strand adjustment is obtained, then the adjustment amount of actual construction of the cable strands is also obtained through the strain incremental adjustment method. With the help of a numerical simulation platform, the calculation program of the cable force adjustment of composite saddle anchor span is established by an iterative solution method. In this paper, taking the Jinsha River Bridge at Hutiao Gorge as a research object, the adjustment of cable force of composite saddle anchor span is analyzed and calculated. The research results indicate that the calculated cable force is obtained by the strain incremental adjustment method, and it is similar to the measured cable force. The cable strand adjustment and optimization method avoids excessive repeated stretching and relaxation of a single cable strand in the process of multiple rounds of cable strand adjustment and reduces the amount of construction adjustment. This method can effectively reduce the times of cable strand adjustment and improve the efficiency of adjusting the anchor span cable force.

The sericite schist is a typical metamorphic soft rock. Large deformation of surrounding rock often occurs in the construction of a tunnel in this stratum. Due to the broken rock mass structure and poor mechanical strength in Baishitou tunnel project of Dalin line of Southwest railway, it is impossible to prepare standard samples for a traditional rock mechanical test. Therefore, we chose penetrometer (SH-70) for an in situ test. Firstly, we monitored the deformation of typical sections and analyzed the characteristics of large deformation of soft rock in the tunnel. Secondly, we tested the needle penetration index of fresh excavation face and side wall. Then, we estimated some mechanical parameters of sericite schist by a needle penetrometer and Hoek-brown criterion and discussed the acquisition of mechanical parameters of soft rock. The results show the following: (1) the characteristics of extrusion rock tunnel are summarized as large deformation, fast deformation rate, and obvious construction disturbance. (2) The reference value of penetration index of sericite schist (the vertical joint direction) is 3.90~7.77 N/mm, and the parallel joint direction is 1.27~2.99 N/mm. (3) The uniaxial compressive strength estimated by a penetrometer is 0.78~8.53 MPa, and the strength of the surrounding rock is negatively correlated with the amount of deformation. Therefore, it can be considered that the insufficient strength of surrounding rock is the fundamental reason for large deformation. (4) The reference value of cohesion of sericite schist estimated by a penetrometer is 0.203 MPa, and the reference value of internal friction angle is 18.224°. Compared with the common estimation methods, the penetrometer is more convenient and economical, which can provide a new idea for obtaining the mechanical parameters of sericite schist soft rock tunnel.