This paper introduces a novel methodology to optimize the design of a ratiometric rotary inductive position sensor (IPS) fabricated in printed circuit board (PCB) technology. The optimization aims at reducing the linearity error of the sensor and amplitude mismatch between the voltages on the two receiving (RX) coils. Distinct from other optimization techniques proposed in the literature, the sensor footprint and the target geometry are considered as a non-modifiable input. This is motivated by the fact that, for sensor replacement purposes, the target has to fit a predefined space. For this reason, the original optimization technique proposed in this paper modifies the shape of the RX coils to reproduce theoretical coil voltages as much as possible. The optimized RX shape was obtained by means of a non-linear least-square solver, whereas the electromagnetic simulation of the sensor is performed with an original surface integral method, which are orders of magnitude faster than commercial software based on finite elements. Comparisons between simulations and measurements performed on different prototypes of an absolute rotary sensor show the effectiveness of the optimization tool. The optimized sensors exhibit a linearity error below 0.1% of the full scale (FS) without any signal calibration or post-processing manipulation.
In this work the solution of the eddy current problem for slowly moving conductors is investigated with the volume integral formulation of the EFIE. If in one hand the formulation gives the possibility to mesh only the conductors, if embedded in a uniform insulator, on the other hand the inductance matrix is fully populated limiting thus the size of the problem. Furthermore, the standard solution implies the reassembling of the stiffness matrix for each position assumed by the moving conductors. This results in a limit in the size of the problem to treat and a relevant cost in the computation time. To overcome this limit, in this work, the mutual coupling part of the system with two conductors is computed on the fly giving thus the possibility to solve problems with a higher number of unknowns. Finally, to speed up the solution of the system, the Gauss–Seidel iterative techniques and the Fast Multipole Method (FMM) are applied to take into account the mutual effects between the conductors. A comparison of the proposed method with a reference one shows the effectiveness of this technique.
This article presents a theoretical study of an absolute, ratiometric inductive position sensor (IPS) based on eddy currents. The aim is to describe the working principle of the sensor, having as key components a transmitting coil, the receiving coils and the conductive target, by introducing area-of-overlap functions. We show that each target–receiver pair needs the adoption of a different reconstruction formula for the identification of the target position, whereas in the literature the usual inverse tangent function is applied for every possible pair. Than, we seek the target–receiver pair that maximizes the amplitude of the induced voltages on the receivers. The results show that, to achieve the maximum value of the induced voltages, the best choice is to have rectangular target and rectangular receivers. In order to verify the theory, a simulation and optimization method has been applied to the rectangular receivers coils on two rotary IPS realized with Printed Circuit Board (PCB) technology. Measurements performed on the prototypes have shown an increment of the induced voltage of more than 57% with respect to the commonly used sinusoidal receivers. However, a linearity error of 1.5%FS is obtained by using the inverse tangent reconstruction formula. When using the formula provided from the theory, the linearity error becomes 0.6%FS for the non-optimized prototype and below 0.15%FS for the optimized one.
20 November 2024 in IEEE Transactions on Magnetics
It is well established that complementary formulations for static electromagnetic problems yield upper and lower energy bounds, a result that has been demonstrated only numerically for magnetoquasistatic (MQS) problems. However, this aspect remains completely unexplored for electroquasistatic (EQS) problems. The primary objective of this paper is to solve an electroquasistatic (EQS) problem for the first time using two complementary formulations. The secondary aim is to address the existing gap in the literature by numerically investigating whether energy bounds exist for EQS problems, following the approach previously applied to magnetoquasistatic (MQS) problems.