Inductive position sensors (IPSs) are contactless sensors used for detecting the absolute position of an item in case of angular or linear motion. The active sensing part is manufactured by positioning copper traces on a printed circuit board (PCB) in order to obtain a system of transmitting and receiving coils. A designing procedure based on trial-and-error method is not considerable because of the low time and costs efficiency of the process. Therefore, the here presented coil design process aims at efficiently evaluating the performance of each sensor before its industrial production and application. The simulation is based on the sequential solution of different eddy current problems in the frequency domain by using a fast and efficient surface integral formulation in place of the much more widely diffused commercial finite element (FE) codes. Due to this innovative practice, simulation time can be reduced to some tens of seconds thus allowing the evaluation of many design and the final performance of the sensor can be deeply enhanced, reducing the maximum linearity error from more than 2% up to 0.2% FS.
This paper introduces a novel methodology to optimize the design of a ratiometric rotary inductive position sensor (IPS) fabricated in printed circuit board (PCB) technology. The optimization aims at reducing the linearity error of the sensor and amplitude mismatch between the voltages on the two receiving (RX) coils. Distinct from other optimization techniques proposed in the literature, the sensor footprint and the target geometry are considered as a non-modifiable input. This is motivated by the fact that, for sensor replacement purposes, the target has to fit a predefined space. For this reason, the original optimization technique proposed in this paper modifies the shape of the RX coils to reproduce theoretical coil voltages as much as possible. The optimized RX shape was obtained by means of a non-linear least-square solver, whereas the electromagnetic simulation of the sensor is performed with an original surface integral method, which are orders of magnitude faster than commercial software based on finite elements. Comparisons between simulations and measurements performed on different prototypes of an absolute rotary sensor show the effectiveness of the optimization tool. The optimized sensors exhibit a linearity error below 0.1% of the full scale (FS) without any signal calibration or post-processing manipulation.
This paper describes safety monitoring features for an inductive rotary position sensor having analog, position dependent sine and cosine outputs. An algorithm is presented that estimates a position error by analyzing the variation of the magnitude or signal strength derived from the sine and cosine output signals. The presented Simulink Model aims at efficiently validating the performance of the safety mechanism (SM) under plausible failure modes during the operation of the product. Random failures could occur in each element of the positioning system. By analyzing simulation results of the injected faults with the Simulink model, it is possible to predict the sufficiency of the magnitude ripple check algorithm. The Simulink model implemented proves to properly verify the implementation of the SM.