Several compact, low profile and metal-attachable RFID tag antennas with a loop-fed method are proposed for UHF RFID systems. The structure of the proposed antennas comprise of two parts: (1) The radiator part consists of two shorted patches, which can be treated as two quarter-wave patch antennas or a cavity. (2) A small loop printed on the paper serves as the feeding structure. The small loop provides the needed inductance for the tag and is connected to the RFID chip. The input impedance of the antenna can be easily adjusted by changing loop dimensions. The antenna has the compact size of 80 mm × 25 mm × 3.5 mm, and the realized gain about dB. The measured results show that these antennas have good performance when attached onto metallic surfaces.
27 February 2020 in ACS Applied Materials & Interfaces
The real-time monitoring of health conditions of humans is a long-lasting topic, but there are two major challenges. First, many biomedical applications accept only implanted sensors. Second, tissue-like soft sensors often suffer from viscoelasticity-induced signal drift, causing inaccurate measurements. Here, we report a wireless and drift-free sensory system enabled by a low-creep polyelectrolyte elastomer. The system consists of the iontronic pressure sensors incorporating inductance-capacitance (LC) oscillators, exhibiting combined low drift ratio, high Q factor, high robustness to interferences, and wide-range measurement, superior to other capacitive sensors using regular dielectrics or ionogels. We have recorded 14-day orthodontic loads of two subjects using the system, showing pressure decreasing from 300 to 50 kPa and torque from 12.5 to 0.5 N·mm. The wireless, drift-free sensory system may be extended to other implants for long-term and accurate sensing.
19 October 2012 in IEEE Antennas and Wireless Propagation Letters
This letter presents a novel dual-band (HF and UHF) radio frequency identification (RFID) tag antenna. Two key challenges are faced: the compact dimension and the impaired bandwidth due to the couplings between two band structures. To enable the implementation of whole design on a credit-card-size single-layer support, a spiral coil along the edges of the card is designed to handle the HF (13.56 MHz) near-field coupling, and the UHF antenna is placed inside the coil instead of outside. Meanwhile, a diagonal symmetric design consisting of two meander lines inside the spiral coil is adopted for UHF band. This structure supports multiple resonance modes around 915 MHz to broaden the working bandwidth under the large inductive circumstance from the HF coil. The proposed antenna is easy for adjustment with ways of handling both coarse tuning and fine-tuning. Its overall dimension is of a credit card size on a single-layer thin substrate. The design methodology and antenna measurement results are both presented and discussed in the letter.
E‐Textiles have gained increasing momentum in wearable electronics recently. Conductive‐yarn‐based embroidered devices, with the advantages of being soft, deformable, breathable, and protective for the skin, play an important role in replacing many metallic counterparts. However, embroidered devices face many new challenges in their design methodology and fabrication processes, such as high resistivity and low Q value of the conductive yarns, as well as deformation of device geometries during wearing. Herein, a strain‐free, deformation‐resilient embroidery process for near field communication (NFC) coil antennas is introduced. Coil geometry can endure extreme deformation by stretching with up to 50% elongation, bending with curvature as small as 16 mm in radius, and can still maintain a relatively small variation in its inductance, resonant frequency, Q value, as well as its energy‐harvesting capabilities. The embroidered coil antenna is used in an NFC‐based battery‐free body sensor system. Experiments demonstrate that the system can maintain a stable performance (voltage supply, temperature sensing, and reading range) under various deformation conditions.