Hydrocyclones are devices used in numerous areas of the chemical, food, and mineral industries to separate fine particles. A hydrocyclone with a diameter of d50 mm was modeled using the commercial Simcenter STAR-CCM+13 computational fluid dynamics (CFD) simulation package. The numerical methods confirmed the results of the different parameters, such as the properties of the volume fraction, based on CFD simulations. Reynolds Stress Model (RSM) and the combined technique of volume of fluid (VOF) and discrete element model (DEM) for water and air models were selected to evaluate semi-implicit pressure-linked equations and combine the momentum with continuity laws to obtain derivatives of the pressure. The targeted particle sizes were in a range of 8–100 microns for a dewatering application. The depth of the vortex finder was varied to 20 mm, 30 mm, and 35 mm to observe the effects of pressure drop and separation efficiency. The split water ratio increased toward a 50% split of overflow and underflow rates as the length of the vortex finder increased. It results in better particle separation when there is a high injection rate at the inlet. The tangential and axial velocities increased as the vortex finder length increased. As the depth of the vortex finder length increased, the time for particle re-entrainment into the underflow stream increased, and the separation efficiency improved.
The study numerically investigated the noise dissipation, cavitation, output power, and energy produced by marine propellers. A Ffowcs Williams–Hawkings (FW–H) model was used to determine the effects of three different marine propellers with three to five blades and a fixed advancing ratio. The large-eddy Simulations model best predicted the turbulent structures’ spatial and temporal variation, which would better illustrate the flow physics. It was found that a high angle of incidence between the blade’s leading edge and the water flow direction typically causes the hub vortex to cavitate. The roll-up of the cavitating tip vortex was closely related to propeller noise. The five-blade propeller was quieter under the same dynamic conditions, such as the advancing ratio, compared to three- or four-blade propellers.
Low-grade Mg waste from post-consumer products and production waste cannot be recycled efficiently and economically. This work addresses this challenge by converting this waste into hydrogen. Mg waste is melt, loaded on one side of a stainless steel and solidified to form a galvanic Mg stainless steel couple. These couples are being used to generate hydrogen in 3.5% by weight CH3COOH solution at 15°C and 20°C respectively. The experimental results show that a mean accumulated H2 volume of 3.17 litres was produced when Mg stainless steel couple had a weight of 48.44 grams and water bath temperature of 15°C. One gram of low grade Mg yielded 2.91 Litres of H2. Another sample at 20°C with a weight of 52.73 grams showed a higher H2 volume yield of 3.21 litres per gram. This work can be expanded to a larger scale as the litres per gram volume indicates a lot more compared to what has been reported in literature.
Hydrogen (H 2 ) economy more and more attention and it is soon to become a priority development to all nations around the globe. H 2 offers a wide range of benefits and the greatest of them all is its ability and flexibility to be used as a green energy carrier. More and more car manufacturers are following suit in moving from prototyping to commercial demonstrations of fuel cell electric cars. Natural gas and coal are currently the cheapest sources of hydrogen and are likely to remain so. In the present study, magnesium waste-based materials from end of life products were used as raw materials in the presence of iron chloride added water solution to generate hydrogen gas. Magnesium (Mg) reacts slowly with water and releases hydrogen at room temperature and this is followed by the formation of magnesium hydroxide on its surface. This reaction was accelerated by an addition of 1.5 wt% of iron chloride. The results confirmed iron chloride as an excellent hydrolysis reaction accelerator with stainless steel as an effective catalyst. On average, the reaction yielded 2700mL of H 2 over 3600 seconds.