Embedding nanoparticles (NPs) in the buffer layer of bulk heterojunction polymer solar cells (BHJ PSCs) excites the surface plasmonic polaritons and enhances the pathlength of the light in the solar cells. On the other hand, embedding NPs in the active layer significantly improves absorption and increases the production of electron-hole (e-h) pairs in BHJ PSCs. Increasing the volume ratio of NPs embedded in BHJ PSCs enables the direct interfacing of the NPs with the active layer, which then serves as a charge recombination center. Therefore, this study integrates the aforementioned phenomena by exploiting the effects of embedding plasmonic Au@Ag NPs in the buffer and active layers of PSC and then determining the optimum volume ratio of Au@Ag NPs. The results show the absorption is increased across the 350–750 nm wavelength region, and the PCE of the device with embedded Au@Ag in two locations is enhanced from 2.50 to 4.24%, which implies a 69.6% improvement in the PCE in comparison to the reference cell. This improvement is contributed by the combined localized surface plasmon resonance (LSPR) effects of multi-positional Au@Ag NPs, spiky durian-shaped morphology of Au@Ag NPs, and optimized volume ratio of Au@Ag NPs embedded in the PEDOT: PSS and PTB7:PC71BM layers.
The localized surface plasmon resonance (LSPR) effects of nanoparticles (NPs) are effective for enhancing the power conversion efficiency (PCE) of organic solar cells (OSCs). In this study, spiky durian-shaped Au@Ag core-shell NPs were synthesized and embedded in the hole transport layer (HTL) (poly(3,4-ethylenedioxythiophene): poly(styrenesulfonate) (PEDOT:PSS)) of PTB7:PC71BM bulk-heterojunction OSCs. Different volume ratios of PEDOT:PSS-to-Au@Ag NPs (8%, 10%, 12%, 14%, and 16%) were prepared to optimize synthesis conditions for increased efficiency. The size properties and surface morphology of the NPs and HTL were analyzed using field emission scanning electron microscopy (FESEM), transmission electron microscopy (TEM), and atomic force microscopy (AFM). UV–Vis spectroscopy and current density–voltage (J-V) analysis were used to investigate the electrical performance of the fabricated OSCs. From the results, we observed that the OSC with a volume ratio of 14% (PEDOT:PSS–to–Au@Ag NPs) performed better than others, where the PCE was improved from 2.50% to 4.15%, which is a 66% increase compared to the device without NPs.