The bend pipe with a circular section, which is widely used in hydropower, chemical industry and other fields, is a common form in pipeline systems. However, secondary flow occurs when the fluid flows through the bend pipe, thereby affecting the stability of the pipeline system. Different bending angles have various effects. Therefore, this paper establishes 3D models of a circular bend pipe with different bending angles. The influence of bending angle on flow field distribution and downstream flow is analyzed numerically. The larger the bending angle is, the more obvious the flow distribution and even the unevenness at the elbow will be, hence resulting in poor stability. The distance required to restore flow uniformity also increases. The pressure energy loss of the bend pipe with different bending angles is investigated. Results show that with the increase in bending angle, the global pressure loss presents a trend of “increase-decrease-increase.” The closer the bending angle is to 90°, the greater the influence of centrifugal force is on the flow, and the more obvious the secondary flow phenomenon will be. Aiming at the nonuniformity phenomenon, the structure optimization of a 90° bend pipe with the greatest influence is conducted. The improvement of the flow characteristics of bend pipe with different thick-diameter ratio and length-diameter ratio is compared. The deflector with a certain thickness can enhance the uniformity, safety and useful life of the bend pipe. The sharp-end length can improve the velocity uniformity to a certain extent but has minimal influence on flow characteristics compared with the thick-diameter ratio. This paper aims to study and improve the flow performance of a multi-structure bend pipe to make it suitable for more complex conditions.
Pump-jet propulsion is gaining attention due to its multifunctional operation, strong hydraulic performance, and low noise levels, especially as traditional propulsion systems begin to reach their performance limits. This research combines computational fluid dynamics (CFD) and computational aeroacoustics (CAA) methods, validated through experiments conducted on a custom test equipment. The analysis explores how various factors such as the inlet flow rate, the impeller speed, and the number of blades affect non-cavitating noise in axial flow pumps. It is found that the lower flow rates, especially under off-design conditions, lead to increased overall sound pressure levels (OASPL). For instance, reducing the flow rate by 200 m3/h results in a 2.74 dB increase in OASPL, whereas a 100 m3/h increase in the flow rate causes only a 0.50 dB rise. Additionally, increase in the impeller speed has a more pronounced effect on overall sound pressure levels (OASPL) than decrease. There is also a nonlinear relationship between non-cavitating noise and the number of blades, indicating complex interactions. These results provide essential insights for predicting non-cavitating noise and optimizing acoustic design in the axial flow pumps.