Precursor signals for earthquakes, such as radon anomalies, thermal anomalies, and water level changes, have been studied in earthquake prediction over several centuries. The atmospheric vertical electric field anomaly has been observed in recent years as a new and valuable signal for short-term earthquake prediction. In this paper, a physical mechanism of the atmospheric vertical electric field anomaly before the earthquake was proposed, based on which the Wenchuan earthquake verified the correctness of the model. Using Monte Carlo simulations, the variation of the radon concentration with height before the earthquake was used to simulate and calculate the ionization rates of radioactive radon decay products at different heights. We derived the atmospheric vertical electric field from −593 to −285 V/m from the surface to 10 m before the earthquake by solving the system of convection-diffusion partial equations for positive and negative particles. Moreover, negative atmospheric electric field anomalies were observed in both Wenjiang and Pixian before the Wenchuan earthquake on 12 May, with peaks of −600 V/m in Pixian and −200 V/m in Wenjiang. The atmospheric electric field data obtained from the simulation were shown to be in excellent concordance with the observed data of the Wenchuan earthquake. The physical mechanism can provide theoretical support for the atmospheric electric field anomaly as an earthquake precursor.
Taiji is proposed as a space‐based gravitational wave (GW) observatory consisting of three spacecraft in a heliocentric orbit meanwhile with the distance of 3 million kilometers ahead of the Earth at about 20°. Free‐falling test masses (TMs) are a key component of the interferometer for space‐based GW detection in the 0.1mHz–1 Hz frequency range. Exposure to energetic particles in the space environment can lead to charging of the TMs and thus cause additional electrostatic forces and Lorentz forces that limit the sensitivity of the interferometer and may affect the quality of the scientific data. This study aims to model the charging of TMs during Galactic cosmic rays and solar proton events (SPEs) using the Monte Carlo simulation toolkit meanwhile with constructing the sophisticated 3D spacecraft. The results show that the total net charging rates are 34.48 +e/s and 33.85 +e/s on TM1 and TM2 during the solar minimum, and 9.58 +e/s on TM1 and 9.65 +e/s on TM2 during the solar maximum. We confirm that no matter for solar minimum or solar maximum, protons contribute to the largest proportion of the TMs charging rate. Furthermore, charging for five typical SPEs is also investigated, and the maximum TMs charging rate reaches 76,674 +e/s, indicating that sporadic SPEs have a high risk for TMs charging. Finally, the charging rates of a TM imitation are tested on ground by the 30–50 MeV proton irradiation experiment, and the experimental results show good consistence with the simulation results with the error <10%.
Free-falling cubic Test Masses (TMs) are a key component of the interferometer used for low-frequency gravitational wave (GW) detection in space. However, exposure to energetic particles in the environment can lead to electrostatic charging of the TM, resulting in additional electrostatic and Lorentz forces that can impact GW detection sensitivity. To evaluate this effect, the high-energy proton data set of the Geostationary Operational Environmental Satellite (GOES) program was used to analyze TM charging due to Solar Proton Events (SPEs) in the 24th solar cycle. Using the Geant4 Monte Carlo toolkit, the TM charging process is simulated in a space environment for SPEs falling into three ranges of proton flux: (1) greater than 10 pfu and less than 100 pfu, (2) greater than 100 pfu and less than 1000 pfu, and (3) greater than 1000 pfu. It is found that SPEs charging can reach the threshold within 535 s to 18.6 h, considering a reasonable discharge threshold of LISA and Taiji. We demonstrate that while there is a somewhat linear correlation between the net charging rate of the TM and the integrated flux of $$\ge$$ 10 MeV SPEs, there are many cases in which the integrated flux is significantly different from the charging rate. Therefore, we investigate the difference between the integral flux and the charging rate of SPEs using the charging efficiency assessment method. Our results indicate that the energy spectrum structure of SPEs is the most important factor influencing the charging rate. Lastly, we evaluate the charging probability of SPEs in the 24th solar cycle and find that the frequency and charging risk of SPEs are highest in the 3rd, 4th, 5th, 6th, and 7th years, which can serve as a reference for future GW detection spacecraft.
Space radiation has been well-known as the main health hazard to crews involved in manned space explorations. Two kinds of hydrogenous-rich composites are developed through compressing molding under high-temperature processing techniques for shielding space radiation. Beams of 80~400 MeV/n 12 C of the Heavy Ion Research Facility in Lanzhou are used to test the shielding properties of the new composites. Experimental results show that the composite with more hydrogen content has higher shielding ability for 80 and 400 MeV/n 12 C particles. Meanwhile, the addition of boron has no obvious effect on improving the shielding performance of the composite. Monte Carlo radiation transport codes were used to assess the shielding performance of composite in real space radiation. The simulation results show that hydrogenous-rich composite has significant advantage in space radiation shielding compared with traditional aluminum.
The radiation environment in the vicinity of Jupiter is extremely harsh. In this context, dominant high-energy electrons are the main cause of the total ionizing dose that seriously threatens the service life of electronic devices aboard spacecraft. In this study, we explore the shielding effect of aluminum–tantalum composite materials in the energy spectrum of the radiation environment of a probe orbiting Jupiter and the planet’s gravity assist orbit at the edge of the solar system by using Monte Carlo simulations. The results show that when the shielding material was sufficiently thick, the composite shield was superior to a shield composed of a single element. Moreover, the lower the apogee of the orbit around Jupiter was, the higher was the flux in the energy spectrum of the electrons, and it was advantageous to use a thin material in the composite shield in this case. As the thickness of the material increased, the mass ratio of Al in the optimal ratio of the Al–Ta composite material gradually increased. The results of this study provide a reference for designing strong shielding materials to protect against radiation in deep space exploration.
When the satellite is on orbit, the surrounding plasma environment will interact with the spacecraft surface, accumulate charges on the spacecraft surface and cause surface charging effect, which could lead to electrostatic discharge and affect the running of the spacecraft. SMILE is a satellite operating in a solar synchronous and high inclination large elliptical orbit. The on-orbit motion will encounter ionospheric plasma, magnetospheric plasma and solar wind plasma, pass through the region of the outer radiation belt enriched by high-energy electrons. These environmental factors can cause the surface charging effect on satellite and affect on-orbit security of the satellite and the acquisition of scientific data. Utilizing the software simulation of spacecraft plasma interaction system, the charging effects of SMILE satellite surface in solar wind plasma, magnetic tail plasma and extremely harsh plasma environment have been simulated, and the charging potential distribution on its surface have been obtained. The results show that the surface charging potential varies in different environments, but all comfort with the design requirements. The analysis of surface current shows that the secondary electron emission has great influence on surface charging in various plasma environments. Under sun illumination, photoelectron emission dominates surface charging. By analyzing the charge current on the surface on the eclipse, the calculated results can supply the experimental curve of the secondary electron emission coefficient of indium tin oxide materials.