Ensuring water availability for agriculture and drinking water supply in semi-arid mountainous regions requires control of factors influencing groundwater availability. In most cases, the population draws its water needs from the alluvial aquifers close to villages that are already limited and influenced by current climatic change. In addition, the establishment of deep wells in the hard rock aquifers depletes the aquifer. Hence, understanding the factors influencing water availability is an urgent requirement. The use of geographic information system (GIS), and remote sensing (RS), together with decision-making methods like analytical hierarchy process (AHP) will be of good aid in this regard. In the Tata basin, located in SE Morocco, ten factors were used to explain the groundwater potentiality map (GWPM). Five categories of potential zones were determined: very low (8.67%), low (17.74%), moderate (46.77%), high (19.95%), and very high (6.87%). The efficiency of the AHP model is validated using the ROC curve (receiver operating characteristics) which revealed a good correlation between the high potential groundwater zones and the spatial distribution of high flow wells. Geophysical prospecting, using electrical resistivity profiles, has made it possible to propose new well sites. It corresponds to conductive resistivity zones that coincide with the intersection of hydrogeological lineaments.

Water scarcity affects all continents, with approximately 1.2 billion people living in areas where water is physically lacking. This scarcity is more accentuated in countries with an arid climate, and its impact becomes more threatening when the economy depends mainly on it. The Kingdom of Morocco, with its agricultural vocation, is one of them, especially in its southern regions. Therefore, mapping areas with high groundwater potential based on available geospatial data allows for optimizing the choice of a future well in such areas. Geometric average and fractal models were used to assess and delineate potential groundwater areas in the Tissent basin, Southeast Morocco. Eight factors, including topography, geology, hydrology, and hydrogeology, influencing the distribution of water resources was used. The formation permeability factor presents the most significant impact among the others, although it is directly related to most of them. The areas located in the central and downstream part of the basin are characterized by a high water potentiality due to increased geological formations’ permeability near the drainage system, which constitutes a recharge zone, and a low slope allowing a prolonged water-formation contact time favoring a gradual infiltration of the water towards the deep aquifers. The groundwater potential map has been edited and validated by comparing it with data from 52 wells scattered throughout the basin. The favorable potential sectors cover 15.81% of the basin’s total area. The moderate ones account for 21.36% while the unfavorable areas cover 62.83%. These results aim to provide policymakers and managers with a guide map for groundwater research and reduce hydrogeological investigation costs.

Groundwater from alluvial aquifers is a critical source of water supply for rural agriculture, particularly in semi-arid and arid regions. Effective management of these aquifers requires an understanding of the factors that influence their water resources. In this study, we present a case study of the Tata watershed in southeastern Morocco, where the economy is heavily dependent on agriculture and relies exclusively on groundwater. We demonstrate the importance of integrating geological, hydrogeological, and geophysical methods to characterize the aquifer and evaluate groundwater productivity. Analysis of 64 data wells tapping into the aquifer revealed significant disparities in flow yields, ranging from 0.05 to 15.50 L per second. The highest yields were found between depths of 12 and 43 m, which correspond to the alluvium and the altered and fractured part of its substrate. The maximum alluvial thickness of 57 m was determined using geo-electrical prospecting. A piezometric map was created to define the recharge zones, which correspond to the lateral contributions of the bordering Georgian limestones, and infiltration of both rain and surface water along the Tata wadi. Since 1987, there has been a continuous drop in groundwater level, which can be attributed to the increase in irrigated areas following financial incentives provided by the Moroccan government to the agricultural sector. A proposal has been made for the construction of a recharge dam to enable the recharge of the alluvial aquifer. This development is expected to serve a dual purpose by mitigating the deleterious impacts of flooding and facilitating the gradual water infiltration of the alluvial aquifer. This case study provides insights into the hydrodynamics of the aquifer and establishes a simplified model of its functioning. These findings have important implications for the management of alluvial aquifers in similar regions.