Smart manufacturing is the demand of industry 4.0, in which the mass production of difficult-to-cut materials is of great concern to fulfil the goal of sustainable machining. Presently, the machining of superalloy is of upmost interest because of its wide application. However, the limited data on the turning of Hastelloy C-276 highlights its challenges during processing. Hence, the machining performance of superalloy considering surface quality, thermal aspects and chip reduction coefficient was examined with minimum quantity lubrication of several oils to address the sustainable development goal (SDG-12). The output responses were optimized through response surface methodology along with analysis of variance. The research exhibited that the output responses were dominated by cutting speed and feed rate having a percentage benefaction of 24.26% and 60%, respectively, whilst the depth of cut and lubricant type have an influence of 10–12%. No major difference in temperature range was reported during the different lubrication conditions. However, a substantial variation in surface roughness and the chip reduction coefficient was revealed. The percentage error evaluated in surface roughness, temperature and chip reduction coefficient was less than 5%, along with an overall desirability of 0.88, describing the usefulness of the model used. The SEM micrograph indicated a loss of coating, nose and flank wear during all lubrication conditions. Lastly, incorporating a circular economy has reduced the economic, ecological and environmental burden.
1 July 2021 in Materials and Manufacturing Processes
Machining of difficult to cut materials at advanced range of machining variable is the requirement of industry 4.0 for achieving sustainable machining goals taking into consideration energy, ecology and economy. However, due to lack of information on the machining data the material is regarded as difficult to cut. Therefore, to enhance the machining performance of Hastelloy C-276 the experimental investigations have been conducted at different levels of input parameters using CNMG120408 cutting inserts under various cooling conditions. The RSM-based CCD approach has been used to to generate the design of experiment along with ANOVA analysis for finding the influence of input factors on the output signal. Investigations results exhibited that the less cutting temperature, better surface quality and lower chip reduction coefficient have been reported in vegetable oil MQL machining. Research pointed out that the S.R. is influenced by cutting speed, doc, cooling environments and feed rate; likewise the impact has been reported for cutting temperature, while the CRC is less dominated by doc compared to other parameter. The percentage errors evaluated for S.R, temperature and CRC have been reported as 0.53%, −1.52% and 1.81% indicates the significance of developed model.
In present investigation, the impact of nanoparticle concentration on the machining accomplishment of Hastelloy C-276 has been examined in turning operation. The outputs like temperature, surface roughness, chip reduction coefficient (CRC), tool wear, and friction coefficient along with angle of shear have been estimated. The graphene nanoparticles (GnP) have been blended into soybean oil in distinct weight/volume ratio of 0.5, 1 and 1.5%. The experimental observations revealed that higher concentration of nanoparticles has enhanced the heat carrying capacity of amalgamation by 12.28%, surface roughness (27.88%), Temperature (16.8%), tool wear (22.5%), CRC (17.5%), coefficient of friction (46.36%) and shear angle (15%). Scanning electron microscopy identified nose wear, abrasion, adhesion and loss of tool coating. Further, lower tool wear has been noticed at 1.5% concentration, while the complete failure of insert has been reported during 116 m/min, 0.246 mm/rev having 0.5% concentration. ANOVA results exhibited that surface roughness is highly influenced by speed rate (41.66%) trailed by feed rate (28.16%) and then after concentration (13.68%). Temperature is dominated by cutting speed (69.31%), concentration (14.53%) and feed rate (13.25%). Likewise, tool wear was majorly altered by cutting speed (67.2%) accompanied by feed rate (23.90%) and thirdly concentration of GnP (5.03%).
25 June 2013 in International Journal of Research in Engineering and Technology