In the present study, forced convective heat transfer of a Water-EG coolant has been compared with Water-EG based nanocoolant in a radiator. Conventional coolant Water-EG was considered in the ratio of 70:30 as a base fluid, for that different proportions of 0.1, 0.2 and 0.3 Vol% has been prepared by the addition of graphene nanoparticles. Graphene nanofluid was synthesized by two-step method. Experimental studies were conducted in a radiator by altering the flow rates and inlet temperature of the coolant in the ranges of 2, 4, 6 and 8 L/min and 50, 60 and 70 °C. Heat transfer parameters like Heat transfer rate, Convective heat transfer co-efficient, Nusselt number, Reynolds number and friction factor are evaluated experimentally. Graphical Abstract
26 June 2021 in Journal of Thermal Analysis and Calorimetry
Experiments have been conducted on a flat rectangular loop heat pipe with water and methanol at heat loads from 40 to 320 W at three orientations of the heat pipe (0°, 45°, 90°) and two filling ratios (33% and 50%). Performance parameters such as thermal resistance, effective thermal conductivity and capillary limit are calculated from the experimental data. The results exhibited that the thermal performance of water is better than methanol with least thermal resistance 0.13 K/W, maximum capillary limit 2626.72 W and an effective thermal conductivity 84490.48 W/mK at a heat load 320 W in horizontal position for 33% filling ratio.
This research work aims to optimize double pipe heat exchanger performance using Taguchi, ANOVA, and ANN. Experimental trials involved varying ferric oxide nanoparticles, cut radius, and volume-based flow rate. Twisted tapes with ratios of 3, 5, and 7 were placed within the tube. Assessed heat transfer characteristics included h, Nu, ff, and thermal performance factor. Taguchi, ANOVA, and ANN optimization techniques were applied to the experimental data. A Taguchi optimization using an L9 orthogonal array focused on input attributes (Vol % of nanoparticles, flow rate, radius of cut), with output attributes being heat transfer co-efficient (h), Nusselt number (Nu), friction factor(ff) and thermal performance factor. Results revealed a notable flow rate effect on enhancing h, Nu, and ff, while the addition of nanoparticles significantly influenced thermal performance. Taguchi and ANOVA were conducted using MINI Tab and ANN was implemented through MATLAB. Test data demonstrated that nanoparticle dispersants in nanofluid significantly improved heat transfer properties, consistent with the noteworthy improvement indicated by optimization techniques. The convective heat transfer coefficient parameter showed improvement with a coolant flow rate of 50.29% and a volume of nanoparticles at 27.32%. The enhancement of Nusselt number (Nu) was influenced by a coolant flow rate of 50.34% and a volume percent of nanoparticles at 34.25%. The thermal performance factor was significantly influenced by the volume percent of nanoparticles (79.75%) and the radius of cut (3.83%).The experimental data aligned well with findings from Taguchi and ANN.