A series of NiFe mixed oxide catalysts were prepared via calcining hydrotalcite-like precursors for the selective catalytic reduction of nitrogen oxides (NOx) with NH3 (NH3-SCR). Multiple characterizations revealed that catalytic performance was highly dependent on the phase composition, which was vulnerable to the calcination temperature. The MOx phase (M = Ni or Fe) formed at a lower calcination temperature would induce more favorable contents of Fe2+ and Ni3+ and as a result contribute to the better redox capacity and low-temperature activity. In comparison, NiFe2O4 phase emerged at a higher calcination temperature, which was expected to generate more Fe species on the surface and lead to a stable structure, better high-temperature activity, preferable SO2 resistance, and catalytic stability. The optimum NiFe-500 catalyst incorporated the above virtues and afforded excellent denitration (DeNOx) activity (over 85% NOx conversion with nearly 98% N2 selectivity in the region of 210–360 °C), superior SO2 resistance, and catalytic stability.
Herein, a series of NiTi-LDHs were synthesized, calcined and tested in the removal of NOx by selective catalytic reduction with NH3 (NH3-SCR). Appropriate calcination temperatures as well as Ni/Ti molar ratios of LDH precursors were systematically identified to achieve optimal catalysis; the results pronouncedly affirmed that the catalytic performances of the as-acquired catalysts were vulnerable to the calcination temperature and Ni/Ti molar ratios, where the Ni4Ti1-400 catalyst presented optimal DeNOx activity (over 90% NOx conversion with nearly 95% N2 selectivity in the region of 240–360 °C), SO2 resistance and stability. Multiple characterization techniques revealed that the excellent catalytic performance of Ni4Ti1-400 could be attributed to the favorable interaction between the Ni and Ti species, consequently resulting in higher specific surface area, enhanced acidity, increased content of the surface Ni3+ species, and improved cycle reactions of NH3-SCR.
As a favorably clean fuel, syngas (synthesis gas) production has been the focus of concern in past decades. Substantial literatures reported the syngas production by various catalytic reforming reactions particularly in methane or ethanol reforming. Among the developed catalysts in these reforming processes, Ni-based catalysts from hydrotalcite-like compounds (HTLcs) precursors have drawn considerable attention for their preferable structural traits. This review covers the recent literature reporting syngas production with Ni-based catalysts from HTLc precursors via methane or ethanol reforming. The discussion was initiated with catalyst preparation (including conventional and novel means), followed by subsequent thermal treatment processes, then composition design and the addition of promoters in these catalysts. As Ni-based catalysts have thermodynamic potential to deactivate because of carbon deposition or metal sintering, measures for dealing with these problems were finally summarized. To obtain optimal catalytic performances and resultantly better syngas production, based on analyzing the achievements of the references, some perspectives were finally proposed.
The DFT method is employed to study the adsorption and reaction behaviors of HC2O4−, H2PO4−, HSO4− and H2O on neutral and anodic aluminum slabs. With the exception of adsorption, the three acid radicals can successively take the two H atoms from the adsorbed H2O on the anodic aluminum slabs, which is the key step of the formation of anodic alumina. The dehydrogenation reaction is dominated by the Coulombic interaction of O and H, respectively belonging to acid radicals and the adsorbed H2O or OH, rather than by the interaction of electronic orbits located on the two kinds of atoms. The experiment of anodic polarization of aluminum verifies the calculation result well.